C8051F061-GQR

The C8051F06x family of devices are fully integrated mixed-signal System-on-a-Chip MCUs with 59 digital I/O pins (C8051F060/2/4/6) or 24 digital I/O pins (C8051F061/3/5/7), and two integrated 16-bit 1 Msps ADCs. Highlighted features are listed below; 

   • High-Speed pipelined 8051-compatible CIP-51 microcontroller core (up to 25 MIPS)

   • Two 16-bit 1 Msps ADCs with a Direct Memory Access controller

   • Controller Area Network (CAN 2.0B) Controller with 32 message objects, each with its own indentifier mask (C8051F060/1/2/3)

   • In-system, full-speed, non-intrusive debug interface on-chip

   • 10-bit 200 ksps ADC with PGA and 8-channel analog multiplexer (C8051F060/1/2/3)

   • Two 12-bit DACs with programmable update scheduling (C8051F060/1/2/3)

   • 64 kB (C8051F060/1/2/3/4/5) or 32 kB (C8051F066/7) of in-system programmable Flash memory

   • 4352 (4096 + 256) bytes of on-chip RAM

   • External Data Memory Interface with 64 kB direct address space (C8051F060/2/4/6)

   • SPI, SMBus/I2C, and (2) UART serial interfaces implemented in hardware

   • Five general purpose 16-bit Timers

   • Programmable Counter/Timer Array with six capture/compare modules

   • On-chip Watchdog Timer, VDD Monitor, and Temperature Sensor

With on-chip VDD monitor, Watchdog Timer, and clock oscillator, the C8051F06x family of devices are truly stand-alone System-on-a-Chip solutions. All analog and digital peripherals are enabled/disabled and configured by user firmware. The Flash memory can be reprogrammed even in-circuit, providing non-volatile data storage, and also allowing field upgrades of the 8051 firmware.

On-board JTAG debug circuitry allows non-intrusive (uses no on-chip resources), full speed, in-circuit debugging using the production MCU installed in the final application. This debug system supports inspection and modification of memory and registers, setting breakpoints, watchpoints, single stepping, Run and Halt commands. All analog and digital peripherals are fully functional while debugging using JTAG.

Each MCU is specified for 2.7 to 3.6 V operation over the industrial temperature range (-45 to +85 °C). The C8051F060/2/4/6 are available in a 100-pin TQFP package and the C8051F061/3/5/7 are available in a 64-pin TQFP package