8N3SV75KC-0073CDI

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Clock/Timing - Programmable Timers and Oscillators are primarily used in electronics and hardware systems to measure time, control event sequencing and regulate frequency and rate of data transfer. The 8N3SV75KC-0073CDI is a clock/timing device and is based on a Programmable Timer and Oscillator design.

The 8N3SV75KC-0073CDI uses a quartz crystal oscillator to create a precision time base. The crystal oscillator creates a signal with a high frequency and very low, accurate jitter. This signal is then divided down to a lower frequency, and then again divided down to a predefined frequency, or frequencies. The main features of the 8N3SV75KC-0073CDI are its wide programmable frequency range, low power consumption, and precision jitter.

The 8N3SV75KC-0073CDI can accept a variety of input frequencies, from 1 Hz to 52.5 MHz, and has a frequency output range of 31 kHz to 320 MHz. This range can be further divided by incorporating a PLL (phase locked loop) circuit. This allows for more precise frequency control and synchronization between different devices.

The 8N3SV75KC-0073CDI can be programmed with a single frequency or with a range of frequencies that can be changed over time. This is useful for applications such as frequency hopping and modulation techniques. The 8N3SV75KC-0073CDI also has an accuracy specified at +/-25 PPM over a range of temperatures and/or voltages. This allows the device to maintain accurate frequency and time measurements in a variety of environmental conditions.

The 8N3SV75KC-0073CDI is used in a variety of applications, including communications systems, industrial instrumentation, and consumer electronics. It can be used in combination with other components to create precision time base systems and accurate frequency and rate measurement systems. It can also be used in complex control systems where frequency and timing accuracy are critical.

In summary, the 8N3SV75KC-0073CDI is a Programmable Timer and Oscillator device suitable for a wide range of applications, ranging from basic frequency control to complex control systems. The device is based on a quartz crystal oscillator, has a wide frequency range, and provides an accuracy of +/-25 PPM. It can be programmed to control event sequencing and to create accurate frequency and rate measurements in a variety of applications.

The specific data is subject to PDF, and the above content is for reference