ASTMHTA-13.000MHZ-XC-E-T

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Oscillators are a class of electronic components that generate and sustain continous electronic signals. They are used to generate signals with various shapes -- triangular, sinusoidal, pulse -- at specific frequencies. The ASTMHTA-13.000MHZ-XC-E-T is one of the most commonly used types of oscillators. Its main application field is for timing purposes in digital circuits, such as the clocks and counters of microprocessors.

The basic design of the ASTMHTA-13.000MHZ-XC-E-T consists of three components: an amplifier, a resistor, and a tunnel diode. The amplifier is used to increase the power of the input signal. The resistor acts as a frequency-dependent impedance, controlling the gain of the amplifier. This creates a positive feedback loop between the amplifier and the resistor, resulting in an oscillation. The tunnel diode is used to regulate and stabilize the frequency of the oscillator.

The working principle of the ASTMHTA-13.000MHZ-XC-E-T is based on the astable multivibrator circuit. The circuit consists of two transistors connected in series. The output of the first transistor is connected to the input of the second transistor, and the output of the second is connected back to the input of the first. This creates a feedback loop, which causes the transistors to switch on and off alternately. This alternating on/off state results in an oscillating square wave signal.

When this square wave signal is filtered through the tunnel diode, it creates a sinusoidal waveform with a frequency of 13.000MHz. This frequency is regulated by the resistor, which adjusts the gain of the amplifier. The output of the ASTMHTA-13.000MHZ-XC-E-T is a sinusoidal waveform at 13.000MHz, which can then be used to create a clock signal for digital circuits.

The ASTMHTA-13.000MHZ-XC-E-T is one of the most commonly used types of oscillators. Its main application field is timing purposes in digital circuits, such as the clocks and counters of microprocessors, and its working principle is based on the astable multivibrator circuit. The output of the ASTMHTA-13.000MHZ-XC-E-T is a sinusoidal waveform at 13.000MHz, which can then be used to generate clock signals for digital circuits.

The specific data is subject to PDF, and the above content is for reference