CMF652M0000BER6

Series:	CMF
Packaging:	Tape & Reel (TR)
Part Status:	Active
Resistance:	2 MOhms
Tolerance:	±0.1%
Power (Watts):	1.5W
Composition:	Metal Film
Features:	Flame Retardant Coating, Moisture Resistant, Safety
Temperature Coefficient:	±25ppm/°C
Operating Temperature:	-55°C ~ 175°C
Package / Case:	Axial
Supplier Device Package:	Axial
Size / Dimension:	0.180" Dia x 0.562" L (4.57mm x 14.27mm)
Height - Seated (Max):	--
Number of Terminations:	2
Failure Rate:	--

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Through Hole Resistors

Resistors are one of the most essential passive components used in electronics and electrical engineering. They are used to control current flow in a circuit, provide bias, or stabilize a voltage. Through hole resistors are designed to fit into a hole in a printed circuit board (PCB). The CMF652M0000BER6 is a 0.25W, 4-pin axial leaded through-hole resistor commonly used in automotive and audio chassis applications.

Application Field

The CMF652M0000BER6 is a small-power resistor designed for high-frequency applications such as automotive, audio, lighting and military applications. Its low electrical & thermal resistance, as well as its high dielectric strength make it suitable for use in strict environmental conditions. Its axial leaded design ensures that it is easy to install and requires minimal space. Its low profile also makes it suitable for in-circuit and through-hole mounting.

Working Principle

The CMF652M0000BER6 resistor works by limiting the current flow in a circuit. When electricity is sent through a resistor, the resistance it produces is inversely proportional to the amount of electrical energy sent through it. A higher resistance value will decrease the flow of electricity through the resistor, while a lower resistance value will increase it. The CMF652M0000BER6 resistor is designed to have a low resistance value in order to minimize the amount of electricity flowing through it. The resistance value of the CMF652M0000BER6 is set by the length of the resistor\'s body and the type of material it is made from. These values can vary by manufacturer depending on the application they are used in. The CMF652M0000BER6 is typically made from ceramic-coated, non-conductive layer which helps to withstand extreme temperatures and environmental conditions. A final layer of metal coating is then applied, which helps reduce the surface resistance of the resistor.When electricity is sent through a CMF652M0000BER6 resistor, electrical energy is dissipated as heat in the resistor\'s body. This is known as Joule\'s Law, which states that the energy dissipated in an electrical component is equal to the voltage of the component multiplied by the current flowing through it. The CMF652M0000BER6 is certified to a power rating of 0.25W, which ensures that it will not overheat and become damaged in typical applications.

Conclusion

The CMF652M0000BER6 axial leaded through hole resistor is a widely used passive component for automotive, lighting, and audio applications. Its low profile and four-pin design make it easy to install and require minimal space. Its low electrical and thermal resistance, as well as its high dielectric strength, make it suitable for use in harsh environmental conditions. The CMF652M0000BER6 is designed to dissipate 0.25W of electric energy in order to prevent it from over-heating and becoming damaged.

The specific data is subject to PDF, and the above content is for reference

Part Number	Manufacturer	Price	Quantity	Description