E-TA2012 3DB N2

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Attenuators

The E-TA2012 3DB N2 attenuator is designed for the purpose of reducing the power or level of an electrical signal, without affecting its frequency character. It is often used when the level of an input signal needs to be reduced, so that it can be better matched to the receiving circuit without distortion. This type of attenuator is particularly suitable for high-power and high frequency applications.

The E-TA2012 3DB N2 attenuator consists of two RF switching elements, and two precision diodes to provide isolation. Each of the elements is optimized for operation at specific frequencies, which is typically 900 MHz. The two elements are switched on and off as required, to provide the necessary attenuation. The elements are connected in a series, so that the signal passes through both elements in order to reach the output. The diodes are used for isolation, and the two outputs are then connected to the input and the output connections, respectively.

When the attenuator is connected to a circuit, it has to be configured properly. This is done by setting the appropriate settings on the front panel, which can be done manually or through the use of the external control. The gain setting is used to determine the amount of attenuation that is required. The gain settings are typically expressed in decibels, which is a logarithmic scale. The settings are usually 6dB, 12dB, 18dB and so on.

Once the attenuator is configured, it can be adjusted to ensure that it is providing the required amount of attenuation to the signal. This is done by connecting a signal generator to the attenuator and adjusting the gain setting. When the attenuator is correctly adjusted, the power of the signal should be reduced by the amount that is specified by the gain settings.

In addition to providing attenuation, the E-TA2012 3DB N also has a wide operating bandwidth. This makes it suitable for applications where a wide range of signals need to be attenuated, such as wireless systems. The attenuation range of the device is usually from around 20 kHz to 15 GHz.

The E-TA2012 3DB N2 attenuator is a reliable and versatile device that can be used in a variety of applications. It can be used to reduce the power of an input signal, to improve signal-to-noise ratio, and to ensure that signals are correctly matched to the receiving circuit. It can also be used to reduce interference from other sources, or to achieve other noise reduction goals.

The specific data is subject to PDF, and the above content is for reference