ECS-100A-283.2

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

ECS-100A-283.2 is an oscillator, commonly known as a voltage-controlled oscillator (VCO). An oscillator is a device which produces a regular, repetitive signal either in the form of an electrical voltage or the sound of a tone. Examples of oscillators are electricity generators, clocks, radios and alarm circuits. An oscillator is an important part of a system because it sets the frequency of the outputed signal at a steady rate.

The ECS-100A-283.2 oscillator is a single-ended version of the VCO that produces a single triangular waveform which can be monitored via the output port. The signal output can be adjusted using the two control port parameters which allow for fine-tuned frequency and amplitude modulation. This oscillator has a frequency range from 1 Hz to 10 Hz, a frequency response within ±10% of the center frequency.

The ECS-100A-283.2 oscillator is primarily used in audio applications including car audio, sound reinforcement systems, general audio systems, or test and measurement systems. It can be used to generate a range of periodic signals, such as square, triangle, or sawtooths. This VCO is also used to produce low-frequency sweep tones, vibrato and tremolo for musical instruments.

The architecture of the ECS-100A-283.2 VCO is based on a conventional RC oscillator circuit, where the RC network is connected to an operational amplifier (OPAMP). The OPAMP controls the gain of the circuit, allowing it to convert input voltage signals to corresponding output voltage signals. The timing of the circuit is affected by the resistor and capacitor values, which determine the frequency of the oscillator. The two control port parameters are used to modulate the frequency of the signal, allowing for fine-tuned frequency control.

The ECS-100A-283.2 oscillator is a low-power device with reasonably accurate signal control. It is capable of producing frequencies of up to 10 Hz with a sensitivity of 6 mV/V. The device is designed to operate from a single power supply between 5V and 12V. The typical current consumption is typically less than 2mA. The device is well-suited for applications where low-power operation and accurate frequency control are important, such as medical and automotive applications.

In summary, the ECS-100A-283.2 oscillator is a single-ended voltage-controlled oscillator which is primarily used for audio applications. The device operates from a single power supply between 5V and 12V and requires only 2mA of current to operate. The architecture of the oscillator is based on a conventional RC oscillator circuit, and the two control port parameters are used to modulate the frequency of the signal. This device is well-suited for applications where low-power operation and accurate frequency control are important.

The specific data is subject to PDF, and the above content is for reference