ELB-2A008 Filters

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

RF filters are components of an electronic device through which signals of various frequencies can pass. They are used in many applications such as communications, radar detection, signal conditioning, radio frequency (RF) amplifiers, and noise suppression. One of these methods to filter RF signals is the ELB-2A008, a low pass filter with excellent stop band performance and low insertion loss.

Application Field of ELB-2A008

The ELB-2A008 is called a low pass filter as it allows only frequency signals below a cutoff frequency to pass while blocking out higher frequency signals. This makes it an ideal choice for applications where low frequency signals such as audio signals need to be filtered out from higher frequency signals such as radio waves. Some of the most common applications of the ELB-2A008 include:

• Radio and television broadcasting
• Military electronics
• Avionics
• Telecommunications
• Industrial control
• Medical imaging systems
• Wireless communication systems

Working Principle of ELB-2A008

ELB-2A008 filters work by allowing only signals with frequency lower than a certain threshold to pass through. This is achieved with the help of an inductor (a coil of wire) and a capacitor (two flat metal plates with a gap between them). When these components are connected in a circuit, they form a resonant circuit, which is tuned to allow only low frequency signals to pass through while blocking out the higher frequencies. The resonant frequency of the filter is determined by the inductance and capacitance of the components and can range from a few Hertz to a few hundred kHZ.

The ELB-2A008 is designed to have a wide stop band. This means that there is an extensive range of higher frequency signals that will be blocked out by the filter. The parameters of the filter are optimized to ensure low insertion loss and low group delay. The stop band attenuation is typically 25+ dB and the pass band ripple is 1 dB.

Conclusion

The ELB-2A008 is a low pass filter designed to block out higher frequency signals while allowing those of a specified frequency to pass through. It is ideal for a range of applications including broadcasting, military electronics, avionics, telecommunications, industrial control, medical imaging systems, and wireless communication systems. The working principle of the filter depends on the resonant frequency of the inductor and capacitor components, and is optimized for low insertion loss and low group delay with a 25+ dB stop band attenuation and a 1 dB pass band ripple.

The specific data is subject to PDF, and the above content is for reference