FCR-50JR-52-130K

Series:	FCR
Packaging:	Tape & Reel (TR)
Part Status:	Active
Resistance:	130 kOhms
Tolerance:	±5%
Power (Watts):	0.5W, 1/2W
Composition:	Carbon Film
Features:	Flame Proof, Safety
Temperature Coefficient:	0/ -700ppm/°C
Operating Temperature:	-55°C ~ 155°C
Package / Case:	Axial
Supplier Device Package:	Axial
Size / Dimension:	0.130" Dia x 0.354" L (3.30mm x 9.00mm)
Height - Seated (Max):	--
Number of Terminations:	2

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Through Hole ResistorsThrough hole resistors are crucial elements in virtually all circuits, as they are the primary means of adjusting voltages and current flow of a given circuit. A resistor, such as the FCR-50JR-52-130K, works by providing a specific amount of resistance to current flow, thereby allowing higher or lower voltages or currents as dictated by the user\'s requirements. This article will discuss the application field and working principle of the FCR-50JR-52-130K through hole resistor.The FCR-50JR-52-130K through hole resistor is an insulated, small size, insulated type consisting of two wire leads and two metal plates separated by an insulating material. It is mainly used for applications such as voltage divider, current limiting, and voltage regulation on circuit boards. This resistor\'s distinct advantage is that it requires only two soldering points for installation, allowing easy circuit board assembly.In terms of its working principle, the FCR-50JR-52-130K works like any other resistor. This means that it resists current flow and so changes the potential difference (voltage) across its two ends due to Ohm’s Law. This potential difference is usually measured in milli volts. The FCR-50JR-52-130K works by allowing only a certain amount of current to flow through it, and thereby slowing down or completely halting the current from flowing further into the circuit. The resistor’s metal plates are connected to two wire leads, one of which is usually connected to a power source, while the other lead is connected to a downstream component of the greater circuit. When current flows through the FCR-50JR-52-130K, it will slow down or completely halt the current depending on its resistance tipping point.The FCR-50JR-52-130K through hole resistor also has an assortment of possible application areas due to its size and resistance range. Most often, it is used as a voltage divider, to limit the current flow to particular components, and regulate the voltage of the circuit. It is also used to balance and stabilize low-noise amplifier circuits, as well as attenuation networks and other applications which need high precision. The FCR-50JR-52-130K is particularly suited to high accuracy applications such as those found in automotive systems as it has an exceptional range of resistance values and is typically able to provide superior performance and reliability even in extreme conditions. The FCR-50JR-52-130K is also used to adjust the trigger level of comparators, optical detectors, and logic circuits, as well as to modify the power supply driving rate of motor controllers. The resistor can also be used to limit the voltage on circuits while providing independent current flow control, speed control for VFDs, and creating bias for LEDs and any other similar application.In conclusion, the FCR-50JR-52-130K through hole resistor is a vital component found in virtually all circuits. This resistor works by providing a specific amount of resistance and allowing higher or lower voltages or currents depending on the user’s requirements. It is commonly used for voltage divider, current limiting, and voltage regulation purposes and has a range of application areas due to its size and resistance range. This makes it an essential component for smooth and reliable operation of circuits in various industries.

The specific data is subject to PDF, and the above content is for reference