MTCDT-210L-US-EU-GB

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

MTCDT-210L-US-EU-GB is a RF receiver, transmitter, and transceiver finished unit.

The MTCDT-210L-US-EU-GB utilizes a brilliant optical design that consists of a wave guide transceiver for RF reception, a tightly coupled-loop system, and a low noise mixer for RF reception and transmission. It is built with a very high-frequency amplifier for receiving signals up to one hundred megahertz and a digital down-conversion module for up-conversion of RF signals.

This unit is well suited for applications where the transmission and reception frequency bands are small and medium scale. It has excellent linearity, is extremely accurate, and stable across wide range of frequencies. It is primarily used in Radar, GPS, point-to-multipoint, broadcast, satellite, and wireless communications, such as cellular mobile phones and PDAs, helping to provide high-speed data transfer.

The MTCDT-210L-US-EU-GB is characterized by its low current consumption, setting a small imprint and low thermal joule effect. Furthermore, it features very high ESD protection, making it reliable and durable. Its flexible control allows designers to program and control the device via the I2C interface feature. Moreover, it has comprehensive indication features including two LEDs and programmable timing output.

In terms of working principle, the MTCDT-210L-US-EU-GB is a three-piece transceiver. It has two components for the receiver and two components for the transmitter. In the receiver, the RF signals being transmitted are first captured by the antenna or transducer and then fed to a high-frequency amplifier (HFA). This HFA amplifies the incoming signal before passing it to the low-noise mixer. This mixer is designed to convert a high-frequency signal to a lower one, allowing it to be combined with a local oscillator (LO) signal. The LO signal is used to mix and match the frequency of the incoming signal.

The resulting output is then sent to the demodulator section and then fed again to the HFA, where the out-of-range signal is eliminated, leaving only the signal within the receiver’s programmed range. Finally, the signal is sent to the control unit, where it is processed and undergoes decoding. The demodulated signal is then forwarded to the controller, allowing it to be interpreted and acted upon.

On the transmission side, the same principle is used. The controller receives the signal to be transmitted, sends it to the modulator, where it is combined with the LO signal. The result is then fed to the high-frequency amplifier, before being sent to the antenna for transmission. Once done, the unit is then reset for the next transmission.

Overall, the MTCDT-210L-US-EU-GB proves to be an excellent device for applications involving the transmission and reception of RF signals. It is a stable, reliable and accurate device, with low current consumption and excellent ESD protection. Its features also make it an easy-to-use device for designers who require a flexible and cost-effective solution.

The specific data is subject to PDF, and the above content is for reference