Allicdata Part #: | 1776-2514-ND |
Manufacturer Part#: |
NAP-10-000 |
Price: | $ 21.40 |
Product Category: | Filters |
Manufacturer: | Cosel USA, Inc. |
Short Description: | LINE FILTER 250VDC/VAC 10A CHAS |
More Detail: | N/A |
DataSheet: | NAP-10-000 Datasheet/PDF |
Quantity: | 6 |
1 +: | $ 19.45440 |
10 +: | $ 18.84650 |
25 +: | $ 18.23850 |
50 +: | $ 17.63060 |
100 +: | $ 17.02260 |
250 +: | $ 15.19870 |
Series: | NAP |
Part Status: | Active |
Filter Type: | Single Phase |
Configuration: | Single Stage |
Voltage - Rated DC: | 250V |
Voltage - Rated AC: | 250V |
Voltage - Rated AC (Phase to Ground/Neutral): | 250V |
Current: | 10A |
Frequency - Operating: | -- |
Applications: | General Purpose |
Approvals: | cURus, VDE |
Operating Temperature: | -40°C ~ 85°C |
Mounting Type: | Chassis Mount |
Termination Style: | Terminal Block |
Inductance: | -- |
Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us: sales@allicdata.com
The NAP-10-000 power line filter can be classified as a part of the Power Line Filter Modules, and is designed primarily for use in mains in commercial and industrial applications. The filter is a mains line attenuator designed to attenuate spurious signals on the mains by reducing the amplitude of any signal which may be present. This module can be used to reduce harmonics from noisy appliances and increase the EMI/RFI immunity of equipment.
The main components of the NAP-10-000 filter include a 10 ohm resistor, a series inductor, and a filter capacitors. The resistor impedes current flow from the power line, acting as a step-down voltage regulator. The series inductor and filter capacitors form the actual filtering section. The inductor acts as a low-pass filter, preventing high-frequency signals, or noise, from entering the power line. The filter capacitors act as a high-pass filter, blocking out low-frequency signals.
In order to configure the NAP-10-000 power line filter, the resistance and inductance values must be adjusted. This is done by adjusting the value of the 10 ohm resistor, the series inductor, and the filter capacitors. Once the values are set, the filter is then connected to the mains by means of the screw terminals. The filter will then operate by blocking out unwanted noise, and reducing the amplitude of any incoming signals.
The NAP-10-000 power line filter can be used in a variety of applications, including telecommunications equipment, electronic equipment, and motors. It can also be used to improve the signal-to-noise ratio of data passing through the power line, as well as to protect sensitive equipment from voltage spikes. The filter can also be used to reduce noise, thereby minimizing the amount of interference in the power line.
The NAP-10-000 power line filter is an effective and reliable filter which can be used in commercial and industrial applications. It is designed to reduce the amount of noise, interference, and voltage spikes present on the mains, thereby protecting sensitive equipment and improving the signal-to-noise ratio of any data passing through the power line.
The specific data is subject to PDF, and the above content is for reference
LINE FILTER 250VAC 20A CHASS MNT
LINE FILTER 125/250VAC 4A TH
LINE FILTER 500VAC 100A CHASSIS
LINE FILTER 480VAC 50A CHASS MNT
LINE FILTER 480/520VAC 36A CHASS
LINE FILTER 480VAC 65A CHASS MNT