Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Through Hole Resistors

A through hole resistor is an electronic component used to limit or regulate the flow of electric current by providing electrical resistance. Through-hole resistors are designed to be used in printed circuit boards (PCB) and are mounted to the board by inserting the leads of the component through the board, soldering them to the appropriate pads on the board and then cutting off the excess leads. They are one of the most basic, flexible and economical electronic components available.

RR01J270RTB Application Field And Working Principle

The RR01J270RTB is a size 01 through-hole resistor from Powertron and is used in numerous different applications. This resistor was designed for use in low-power, low-voltage electrical circuits where only a small amount of current is required. It can also be used in power systems, motion control systems, telecommunications equipment, and consumer electronics. The resistor has a maximum power rating of 0.25 watts.

The RR01J270RTB features a typical resistance range of 2 - 270 Ω, a maximum operating temperature of +100°C (212°F) and a maximum power rating of 0.25 watts. It also features a ceramic body for increased durability and a high dielectric strength to resist short circuit currents. Additionally, the resistor has a low thermal resistance and noise for accurate data transmission in analog circuits.

In order to determine resistance, the RR01J270RTB works by limiting the flow of electric current. This is done by introducing a material that resists the flow of electricity, known as a resistive material, into the circuit. As voltage is applied to the resistor, electrical energy is lost due to the resistance. This resistance causes a drop in voltage, and is known as voltage drop. The amount of voltage drop depends on the resistance of the resistor and the amount of current flowing through it. By adjusting the resistance of the resistor, it is possible to control the amount of current that flows through the circuit.

The RR01J270RTB can be used in a variety of applications, including over-current protection, voltage regulation, signal mixing, noise reduction, frequency division, and wave shaping. It is also commonly found in telecommunications, consumer electronics, power conversion, motor control and circuit protection applications. The RR01J270RTB is a great choice for low-power electrical circuits due to its durability, low thermal resistance, and high dielectric strength.

The specific data is subject to PDF, and the above content is for reference