SC-05-10J

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Common Mode Chokes are devices intended to reduce electromagnetic interference of a specific frequency band by passing the signal through a coil. The SC-05-10J is a type of common mode choke used in a variety of electrical applications, including power conversion, high frequency signal isolation, special inductors, wave filters, and signal and periodic line filters.

The SC-05-10J consists of a ferrite core and two wires around it, providing two windings; one primary and one secondary. The ferrite core serves as an inductor, providing the inductance to the circuit and effectively isolating any signal or interference that would otherwise pass through the wire. By passing signals through the core, the inductance of the core causes a separate current to be induced in the secondary winding.

The SC-05-10J is designed to provide a wide range of inductive impedance, ranging from 1 to 600Ω. It is also made with an universal terminal, so the top and bottom terminals are interchangeable. This wide range of inductive impedance means it can be used in applications where the signal voltage needs to be blocked, allowing it to be used in many applications. For example, it can be used in power conversion and motor control systems, or as a filter for signals at high frequencies. The choke can also be used to reduce noise and other interference on various circuits.

In order to achieve superior performance, the SC-05-10J is designed with a shielded body that allows it to operate at temperatures ranging from -25° to +85°C. The shielding minimizes any potential interference passing through the wires. The core of the choke is coated with an epoxy insulation material that is designed to be highly re-radiating, allowing it to reduce noise and other interference from outside sources.

The SC-05-10J can be used in both AC and DC applications. In AC applications, it acts as an inductor, blocking the flow of current and thereby limiting the amount of electricity that can pass through. In DC applications, it acts as a filter, reducing the amount of electromagnetic interference that can pass through. This is done by passing signals through the core, allowing them to be filtered before they reach the destination.

The SC-05-10J is a very versatile and useful tool that can be used in a variety of applications, allowing it to reduce electromagnetic interference and make electronic circuits more efficient. It is a great solution for reducing noise and interference in circuits that must be kept clean and protected from outside sources, ensuring the safety and stability of the components.

The specific data is subject to PDF, and the above content is for reference