SN75LBC176AP

Series:	--
Packaging:	Tube
Part Status:	Active
Type:	Transceiver
Protocol:	RS422, RS485
Number of Drivers/Receivers:	1/1
Duplex:	Half
Receiver Hysteresis:	50mV
Data Rate:	30Mbps
Voltage - Supply:	4.75 V ~ 5.25 V
Operating Temperature:	0°C ~ 70°C
Mounting Type:	Through Hole
Package / Case:	8-DIP (0.300", 7.62mm)
Supplier Device Package:	8-PDIP
Base Part Number:	SN75LBC176A

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Introduction

SN75LBC176AP is an octal Non-Inverting Line Driver and Receiver integrated circuit (IC). It is a low voltage, low current, high-speed operational amplifier. The SN75LBC176AP is designed to provide an open drain output with a wide voltage swing that is suitable for driving capacitive loads. The input is protected from excessive forces, and the outputs are protected from excessively large currents. The SN75LBC176AP can be used in many applications, ranging from low speed data transmission and conversion, to high speed bus applications.

Application Field

The SN75LBC176AP can be used in a variety of applications such as communication networks, data acquisition systems, and monitoring and control systems. It can be used for transmitting and receiving both digital and analog data. It can also be used in systems that require high speed data transfer, such as Ethernet, USB and Firewire. This chip can be used as a line driver, line receiver, transceiver, or active filter.In addition, this IC can be used in automotive applications such as ADAS (Advanced Driver Assistance Systems). It can be used to detect objects in the environment such as pedestrians and vehicles, or to detect obstacles or other hazards on the road. It can also be used to monitor driver data, such as speed and acceleration, or engine performance.

Working Principle

The working principle of the SN75LBC176AP is based on the Non-Inverting Line Driver, which uses two independent two-terminal input stages. This arrangement allows the chip to drive positive and negative input voltage levels and sunk current simultaneously. The input to the Non-Inverting Line Driver is clamped to ground and source currents which prevent the input from being overdriven.The output stage of the SN75LBC176AP is an open drain configuration, which can drive large capacitive loads. The output stage is implemented by using two MOSFETs connected in series at the output terminal. The Drain of each MOSFET is connected to the output terminal and the Gate of each MOSFET is connected to the output of the two-terminal input stage. The output of the chip is controlled by the two-terminal input stage and can be driven high or low depending on the input voltage and the impedance of the load.The SN75LBC176AP can be used in a wide range of applications and has a wide range of possible output configurations which can be tailored to fit specific applications. It can be used as a line receiver, line driver, transceiver or active filter, providing a solution for high speed data transfer applications.

Conclusion

The SN75LBC176AP is an octal Non-Inverting Line Driver and Receiver integrated circuit which is designed to provide an open drain output with a wide voltage swing that is suitable for driving capacitive loads. This chip can be used in many applications, ranging from low speed data transmission and conversion, to high speed bus applications. It can be used as a line driver, line receiver, transceiver, or active filter, providing a solution for high speed data transfer applications.

The specific data is subject to PDF, and the above content is for reference

Part Number	Manufacturer	Price	Quantity	Description