TX41AB00-2216H-CS8232

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Circular connectors have been used for decades in a variety of applications, from consumer electronic devices to aircrafts and ships. However, the narrowing gap between the rear of the connector and the entrance to the electronics creates an potential for environmental threats such as water, dust and vibratory stresses. In order to prevent such threats, the use of backshells and cable clamps has been the preferred solution.

TX41AB00-2216H-CS8232 is a perfect example of a circular connector with backshell and cable clamp. It is a 8 pole, female connector with an extended backshell for strain relief, usually found in automation and industrial applications. This connector is standard according to military specification (MIL-DTL-3420), and supports limited data speeds up to 25 Mbps.

The most common use of TX41AB00-2216H-CS8232 is for connection from a cable assembly or robot arm to an industrial control box. In this case, the connector’s backshell provides needed protection against dust, water, and other environmental threats, allowing the cable to be securely fastened to the control box without worrying about the potential of failure from these threats. Additionally, the cable clamp attached to the connector provides additional strain relief for the cable, allowing it to move freely without damaging the cable.

The working principle behind TX41AB00-2216H-CS8232 is quite simple. The connector is designed so that the contacts are recessed into the body of the connector, allowing the backshell to fit snugly over the front of the connector. This prevents dust, water, and other particles from entering the connector. Additionally, the backshell and cable clamp are attached to the body of the connector with screws, providing an additional layer of protection from environmental threats.

In addition to providing environmental protection, TX41AB00-2216H-CS8232 also provides reliable data transfer. The contacts are made from copper, which provides maximum conductivity and data speeds up to 25 Mbps. Additionally, the connector features a stainless steel finish, which helps protect against corrosion and wear. Finally, the connector is designed for a temperature range of -55°C to 125°C, which ensures the connector will work reliably for a wide range of applications.

In conclusion, TX41AB00-2216H-CS8232 with backshell and cable clamp is the perfect choice for circular connector applications requiring environmental protection and high-reliability. It is an ideal solution for industrial, automation and high-speed data transfer applications.

The specific data is subject to PDF, and the above content is for reference