1300630280

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

1300630280 or SCR (silicon-controlled rectifier) is a four-layer solid state static- induction thyristor switch used in power electronics applications. As a current regulator, the power output of an SCR can be modulated by controlling its firing angle and using one of three common techniques: phase-control, cyclo-control, or pulse width modulation (PWM). It is typically used in applications that require switching high power, such as motors, appliances, heaters, light dimmers, and power supplies.

In application, an SCR is connected to an AC voltage source, such as the main power supply of the device. A gate bias voltage is required to turn on the SCR, meaning that the current passing through the device must be increasing when the gate bias is applied in order to produce a conductive channel. The firing angle for the device is set by adjusting the gate bias voltage and firing time. SCRs can be triggered by both AC and DC gate signals.

Phase-control is a method of controlling the SCR’s power output by modulating its firing angle. In this method, the on angle is set to a value for the device that is less than the operating angle of the device. This causes the power output of the device to be limited at each cycle, producing a sinusoidal waveform. The device’s current characteristics are then regulated by adjusting the off angle of the device, allowing for continuous modulation of current at all points in the period.

Cyclocontrol is another method of controlling the SCR’s power output by modulating its firing angle. In this method, the device is triggered once at the beginning of each period and held in the on state until the desired firing time is reached. As the firing time increases, the device’s power output increases until the desired level is reached. This method allows for precise control of the power output, with very little deviation from the desired level.

Pulse-width modulation (PWM) is the final method of controlling the SCR’s power output by modulating its firing angle. In this method, the device is triggered multiple times within the same period, with the amount of time between each trigger determining the amount of power output for that period. This method allows for extremely precise control of the power output, as well as the ability to vary the power output very quickly.

In addition to regulating power output, SCR’s can also be used to protect circuits or other devices from damage caused by overcurrents or surges. An SCR will immediately cut off power to a device or circuit if the current exceeds a certain limit, thus protecting the device or circuit from damage. This function is used in many applications, such as motor and appliance protection, as well as for controlling the output of motor drives.

As a result of its simple operation, high power handling capabilities, and flexibility, the SCR is widely used in a variety of industries for power regulation and protection applications. They can be found in virtually any power electronics device, from simple household appliances to complex industrial equipment and machinery.

The specific data is subject to PDF, and the above content is for reference