4814P-1-102

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Resistor Networks, Arrays and the 4814P-1-102 are critical components in a variety of applications. This resistor network is the ideal choice for use in switching, signal conditioning, impedance matching/attenuation, and other low-frequency analog applications. By using a combination of voltages, resistors, and capacitors, a resistor network can be configured to manipulate signals and voltages in a variety of ways. The 4814P-1-102 is a very popular resistor network due to its outstanding performance and price.

A resistor network is an electrical network consisting of resistors arranged in a specific manner, usually to provide a specific resistance. A resistor network is usually used to limit the current in an electrical circuit. A typical example is a voltage regulator, which consists of two resistors connected in series to divide a voltage and serve as a current limiting device. Resistor networks can also be used to divide frequencies and increase the impedance of certain types of circuits.

The 4814P-1-102 is a resistor network primarily used as an attenuator. It consists of 10 resistors arranged in a resistance ladder configuration. The result is a network with one input and three output nodes, each of which outputs a voltage that is proportional to the input voltage but approximately 100 times smaller. This network is useful for attenuation of both alternating and direct current signals. It is also commonly used to control the gain of audio or RF signals. The 4814P-1-102 can also be used in switched networks, such as filters and amplifiers, to provide switched or stepped attenuation.

The working principles of the 4814P-1-102 are simple. All nodes in the network are connected in parallel, which results in a voltage division of the input voltage. As the ratio of output voltage to input voltage is proportional to the ratio of output resistor to input resistor, all output nodes output a voltage that is 100 times weaker than the input voltage. This makes the 4814P-1-102 an ideal choice for voltage division, attenuation, and other low-frequency analog applications.

The 4814P-1-102 is a popular choice for an array of applications. It is particularly well-suited to applications requiring voltage division or attenuation in combination with other components. It is also useful in those applications where a switched network is needed to achieve stepped attenuation or filtering, as its 10-resistor layout can be used to switch in resistance at different steps along the network.

The 4814P-1-102 resistor network is a popular choice for those applications requiring low-frequency analog signal processing. Its simple voltage division and capacity for switched networks makes it ideal for applications such as signal conditioning, impedance matching, and attenuation. Its consistent performance and reasonable price make it the ideal choice for a wide range of applications.

The specific data is subject to PDF, and the above content is for reference