52-160-006-A

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Electromagnetic interference (EMI) and radio-frequency interference (RFI) are both forms of electromagnetic radiation. EMI is generated by electrical and electronic devices, while RFI is generated by radio waves. EMI/RFI Filters, or LC/RC Networks, are designed to reduce the amount of interference entering a system. The 52-160-006-A is an example of a LC/RC Network.

The 52-160-006-A is a compact, low-profile, cost-effective filter designed for applications requiring maximum attenuation of EMI/RFI. It is a two-stage, two-port filter, with a maximum attenuation of 50dB in the frequency range of 10kHz to 300MHz. The filter can be used in applications such as cable, control panel, point-of-use, and equipment installation. It is also well suited for medical, aerospace, and automotive applications.

The primary component of the 52-160-006-A is the inductor-capacitor (LC) network. The network consists of two coils – one inductor and one capacitor – placed in series. The inductor acts as a high frequency filter, while the capacitor acts as a low frequency filter. The inductor and capacitor are connected to two ports on the filter and form the first stage of the filter. The second stage is a series of Resistor-Capacitor (RC) networks, which are used to improve the filter’s performance at higher frequencies.

The filter is designed to work by reducing the amount of interference entering a system. It works by absorbing the interference, which is then dissipated as heat. The absorption of interference is dependent on the design of the filter and the environment in which it is placed. The filter is designed to absorb interference from its two ports, which ultimately reduces the amount of EMI/RFI entering the system.

In order to ensure that the filter is working properly, it must be tested periodically. This is done using a test signal generator and an oscilloscope. The oscilloscope will be used to measure the levels of interference at different frequencies. The test signal generator will be used to measure the attenuation provided by the filter at the given frequency. The filter should be tested at multiple frequencies to ensure that it is providing the desired amount of attenuation.

The 52-160-006-A is an effective filter for reducing the amount of EMI/RFI entering a system. It is designed to provide maximum attenuation in the 10kHz to 300MHz range. The filter is relatively easy to install and requires only minor maintenance. The filter should be tested periodically to ensure that it is providing the desired amount of attenuation.

The specific data is subject to PDF, and the above content is for reference