54FCT244CTDB

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The 54FCT244CTDB is a integrated circuit belonging to the logic – Buffers, Drivers, Receivers, Transceivers category. These integrated circuits are used in a variety of applications including digital logic and interface.

Application Field of the 54FCT244CTDB

The 54FCT244CTDB is a high-speed octal bus buffer designed for digital design applications. It is ideal for interfacing TTL and CMOS devices to bus lines, and also for driving large loads such as LEDs or capacitive loads. It is also used to reduce system power consumption by increasing the load current.

The 54FCT244CTDB is also used to interface digital devices in local area networks, serial interfaces, and storage devices such as solid state drives (SSDs). Additionally, it can be used to reduce power consumption in systems where several devices may be connected in parallel with each other.

Working Principle of the 54FCT244CTDB

The 54FCT244CTDB is an octal bus buffer integrated circuit. It is used to interface to or drive multiple lines or buses with TTL or CMOS logic levels. It is designed to drive up to eight lines or buses with a logic signal from a single signal line.

The 54FCT244CTDB gets its power from a single 5V power supply, and it uses this power to generate a higher voltage for driving the eight lines or buses. This is done by using an integrated charge pump circuit that generates a higher voltage level than the input voltage, and this is used to drive the eight lines or buses. Additionally, the charge pump also serves to reduce power consumption by only activating the charge pump when the devices is writing data to the buses.

The 54FCT244CTDB also contains integrated ground drivers that allow the device to drive both TTL and CMOS logic levels. This allows the device to interface with different types of devices and logic families. Additionally, the device has an output enable/disable pin, which is used to disable the output drivers when not in use and allow the device to remain powered down.

Finally, the 54FCT244CTDB has a tri-state output pin. This pin can be used to switch the output drivers between an active and inactive state, allowing for read and write operations on the buses. Additionally, the tri-state pin can also be used for extra power saving, as it can be used to disable the device when it is not in use.

The specific data is subject to PDF, and the above content is for reference