74LCXP16245MEA

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The 74LCXP16245MEA is a logic integrated circuit, which belongs to the field of logic - buffers, drivers, receivers, and transceivers. It is a dual 16-bit parallel transceiver which contains four bidirectional transceivers that can control direction and can operate as sink or source. The 74LCXP16245MEA is used in applications such as the transmission of data between two or more digital devices or circuits, the storage and retrieval of data, the conversion of parallel data to serial data, and the transmission of data in both directions. This logic integrated circuit provides high-speed data transfer up to 25 Megabits/sec and wide supply voltage range of 2.0 to 5.5V.

The 74LCXP16245MEA consists of four, sixteen-bit of transceivers controlled by two active low arc-enable controls, OE1 and OE2. The 74LCXP16245MEA has two input ports, A and B, and two output ports, Y and Z. The two output ports are enabled when OE1 is LOW, and the two input ports are enabled when OE2 is LOW. The logic integrated circuit also has two output enable properties, EN1 and EN2, which respectively control the output drivers of ports Y and Z. The EN1 and EN2 signals are used to control the output ports when OE1 is LOW and OE2 is HIGH, respectively. The 74LCXP16245MEA is also equipped with a di-directional clock signal that is used to synchronize data on both input and output ports.

The 74LCXP16245MEA has a three-state capability that enables the user to extend the data path or the device without contention. It also has an internal feedback path, which allows the output buffer to drive the corresponding input buffer. This feedback loop can also be used to communicate with the peripheral devices, such as multiplexers and programmable logic devices.

In order to use the 74LCXP16245MEA, several conditions must be satisfied. The logic signals must be able to stay in the logic states for sufficient amount of time for proper operation. This means that the trailing edge of the signal must be wide enough so that it does not reset the logic device. The logic signals must also conform to the timing specificiation of the 74LCXP16245MEA.

The 74LCXP16245MEA can operate at speed up to 25Megabits/sec. The device requires slow setup time and small hold time to ensure that the data being transferred is accurate and that the device is able to switch properly. It also requires minimal power during standby so that it can work as an energy efficient device. The 74LCXP16245MEA also contains level shifters to provide extra compatibility between devices with different logic levels.

The 74LCXP16245MEA is typically used in applications such as data communication, data storage and retrieval, bit conversions and as a glue logics for various peripheral circuits. This can be used in consumer electronics or industrial applications where high speed data communication is needed. It can also be used to transfer data to and from multiplexers and other programmable logic devices.

The specific data is subject to PDF, and the above content is for reference