AQW214EH

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Solid State relays (SSRs) provide a viable and reliable alternative to mechanical relays which utilize electrical contactors to isolate control signals. The use of solid-state technology eliminates contact wear and potential failure due to mechanical contact bounce, jamming, and arcing. SSRs operate without any moving parts and have a much longer service life than traditional mechanical relays. The AQW214EH is a Solid State Relay which is used in a wide variety of applications, such as motor control and circuit switching.

The AQW214EH is a single-pole, double-throw, open-frame style SSR with an LED indication for status indication. The AQW214EH can be used to switch AC loads up to 50 Amps and it has a wide range of input voltage options of 12-480 VAC or 12-230 VDC. It features a maximum surge current of 125 Amps and an AC switching capability of 125 Amps. The AQW214EH is also operable at a wide temperature range of -40°C to +80°C.

The AQW214EH utilizes a thyristor, which is a solid-state electronic switch, as its switching device. A thyristor is a three-terminal semiconductor device which acts as a current-controlled switch. It can be triggered using a current signal, normally through the control signal input terminals. When a particular voltage level is reached at the gate terminal of the thyristor, the thyristor conducts current and allows the load current to flow through the relay. If the input voltage is taken away, the thyristor remains in the on position due to the stored charge inside the thyristor.

The AQW214EH is usually controlled using a DC control voltage, typically 5 or 12 VDC. This requires like a DC power source to be used, either from the mains supply or from a separate DC power source. Once the input DC control voltage is applied to the AQW214EH, the relay will be activated and allow current to pass through it. The AQW214EH can also be controlled using a 3-phase supply, in which case the control voltage is applied to each of the three phases in order to trigger the relay. The control voltage must reach the minimum gate triggering voltage in order for the relay to be activated.

The AQW214EH can be used in a variety of applications such as motor control, lighting control, and circuit switching. In motor control applications, the AQW214EH can be used to switch on and off motors, pumps, and other loads. The AQW214EH can also be used for lighting control applications, where it can be used to switch on and off lighting fixtures. Moreover, the AQW214EH can be used to switch circuits, such as computer circuits and automotive circuits. it can also be used to provide remote control of circuits, allowing for remote on/off operations to be performed.

In conclusion, the AQW214EH is a Solid State Relay commonly used for motor control, lighting control, and circuit switching applications. It features a thyristor as its switching device and can be controlled using either a DC control voltage or a 3-phase supply. The AQW214EH is a reliable and cost-effective solution for applications requiring remote control of loads.

The specific data is subject to PDF, and the above content is for reference