EL3032S1(TA)-V

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Optoisolators, also known as optocouplers, consist of an optically sensitive input device on one side and an electrically isolating but optically coupled output device on the other. This isolation between the two sides helps protect the devices from interference, noise, and electromagnetic surges. One type of optoisolator is the Triac, SCR Output optoisolator. An example of this type of optoisolator is the EL3032S1(TA)-V.The EL3032S1(TA)-V is a triac, SCR Output optoisolator and provides an isolated interface between a microcontroller and other electrically isolated loads. It is a split package with a 6 pin SOT-223 package at the input and a 5 pin SOT-223 package at the output. The input side of the optoisolator consists of an integrated LED and current limiting resistor connected in series. The LED is triggered by a voltage pulse that is connected across the anode and cathode pins. When the LED in the EL3032S1(TA)-V is triggered, the light is detected by a photodiode in the output side of the optoisolator. This light triggers a normally off, SCR (Silicon Controlled Rectifier) triac. Once triggered, the triac is turned on until the voltage is removed or the triac, SCR is reset. The optoisolator has a minimum isolation voltage of 5300 volts peak, allowing for good electrical isolation between the input and output sides. The input side has a wide operating voltage range of 3.5V to 60V, allowing it to be used with a variety of power sources. The output side is on a 5 pin SOT-223 package with an SCR output, capable of controlling a triac up to 5A RMS. The optoisolator is used in a broad range of applications where electrical isolation is required, such as motor control, security systems, LED dimming, robotics, and much more. It is commonly used where there is a need to control high voltage or high current devices with a low voltage or low current control signal. Its applications include switch mode power supplies, lighting control, elevator controls, and many industrial and consumer applications. The Triac, SCR Output optoisolator is an effective solution for isolating high voltage and current loads from low voltage control signals. The EL3032S1(TA)-V is a reliable, easy to use optoisolator that can be used in a wide range of applications where electrical isolation is required.

The specific data is subject to PDF, and the above content is for reference