FT2232C-REEL

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The Universal Asynchronous Receiver Transmitter (UART) is a form of communication that facilitates the transfer of data between two components or systems. UARTs are typically used in embedded systems, such as microprocessors and microcontrollers, to connect to peripherals and peripherals to other components in a system.

FT2232C-REEL is a high-performance dual channel serial peripheral USB to UART bridge chip. It supports up to two serial ports. It is used in applications such as industrial control, medical systems, gaming, communications, consumer electronics and more.

The FT2232C-REEL connects a computer\'s USB port to two Enhanced UARTs, which are full-duplex, asynchronous serial ports based on Universal Serial Bus (USB) architecture. Each port supports full modem control, optional IrDA and second generation UARTs that include a generic bit-bang mode and programmable baud rates up to 3 Mbps. It has low power consumption, providing up to 240 mA of supply current and is capable of driving most loads.

The FT2232C-REEL has two independent Serial UARTs. Each has a bidirectional asynchronous serial port with 4 signal pins. The 4 signal pins are TXP, RX, RTS and CTS. The RX and TX pins are the receive and transmit pins, respectively, through which data is sent and received. The RTS and CTS lines are used to control the flow of data between two devices, allowing the receiver to stop the flow when it cannot accept more, then resume it when it is ready for more.

The FT2232C-REEL is programmed to accept various protocol standards such as: RS-232, RS-485, etc. It also has various frequency operation modes and can support multiple baud rates of up to 3 Mbps. The various protocol standards can be programmed and adjusted via the bridge chip\'s EEPROM.

The FT2232C-REEL works by receiving the data from the USB port, converting it into serial data and then sending it out on its TXP line. It also takes the data sent into its RX line and converts it back into USB data that can be read by the computer.

The FT2232C-REEL can also be used to communicate with devices that are not USB-compatible by directly connecting them to the chip’s UART lines. This allows the device to communicate with any UART-compatible device through FT2232C-REEL\'s built-in bridge.

The FT2232C-REEL is an ideal solution for applications that need to bridge between USB and UARTs. It is easy to implement and has a wide range of applications. The chip provides a level of performance that is hard to beat and is suitable for use in various systems such as consumer electronics, industrial control, gaming, and more.

The specific data is subject to PDF, and the above content is for reference