HCPL-2411#060

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Optoisolators are an important part of electronic designs due to the ability to isolate electrical signals from one device to the next. The HCPL-2411#060 is an optoisolator in the Logic Output class, designed for amplifying low speed digital signals, and has a large number of applications for sensing, protection and interface tasks. This article will explain the working principle and fields of application of the HCPL-2411#060.

The HCPL-2411#060 is packaged in a 6-pin dual-in-line small outline IC (SOIC) package with a plastic body and consists of a gallium arsenide infrared (GaAIr) emitting diode optically coupled to an integrated circuit with a transistor output. The device is rated to operate over a wide temperature range of 0°C to +70°C, and an isolation voltage of 5000VRMS. This optoisolator has a typical current transfer ratio (CTR) of 75% and a maximum collector-emitter breakdown voltage of 60V.

The working principle of the HCPL-2411#060 optoisolator is quite simple. The input side of the optoisolator consists of an infrared emitting diode which is powered by the input signal. When the input signal is applied to the diode, the light emitted by the diode will be proportionally amplified by the integrated circuit. This signal is then transmitted through the insulating barrier to the output side, where it is then further amplified and transmitted to the load. In the HCPL-2411#060, the output side is a transistor switch.

The HCPL-2411#060 optoisolator has a wide variety of applications due to its small size and high level of isolation. Some of the most common applications for this device include interfacing low voltage logic circuits for protection against high voltage switching transients, as well as sensing high voltage, high current levels. It is also used in motorcontrol circuits, input protection, and as a miniaturized shield driver to allow for switching with higher speed. Additionally, the HCPL-2411#060 can be used in battery-powered applications due to its low power requirements.

In conclusion, the HCPL-2411#060 is an optoisolator in the Logic Output class, designed to amplify low speed digital signals with a high degree of insulation. It is used in a wide variety of applications, including low voltage logic circuits, motorcontrol circuits, input protection, and as a miniature shield driver. This device is also suitable for battery-powered applications due to its low power requirement.

The specific data is subject to PDF, and the above content is for reference