MCP23S17-E/SO

Due to market price fluctuations,if you need to purchase or consult the price.You can contact us or emial to us:   sales@allicdata.com

1. Describe

The MCP23S17-E/SO device family provides 16-bit, general purpose parallel I/O expansion for I2C bus or SPI applications. The two devices differ only in the serial interface: MCP23S17-E/SO interface The MCP23S17-E/SO consists of multiple 8-bit configuration registers for input, output and polarity selection. The system master can enable the I/Os as either inputs or outputs by writing the I/O configuration bits (IODIRA/B).

The data for each input or output is kept in the corresponding input or output register. The polarity of the Input Port register can be inverted with the Polarity Inversion register. All registers can be read by the system master.

The 16-bit I/O port functionally consists of two 8-bit ports (PORTA and PORTB). The MCP23S17-E/SO can be configured to operate in the 8-bit or 16-bit modes via IOCON.BANK.

There are two interrupt pins, INTA and INTB, that can be associated with their respective ports, or can be logically OR’ed together so that both pins will activate if either port causes an interrupt.

The interrupt output can be configured to activate under two conditions (mutually exclusive):

  1. When any input state differs from its corresponding Input Port register state. This is used to indicate to the system master that an input state has changed.

  2. When an input state differs from a preconfigured register value (DEFVAL register). The Interrupt Capture register captures port values at the time of the interrupt, thereby saving the condition that caused the interrupt.

The Power-on Reset (POR) sets the registers to their default values and initializes the device state machine.

The hardware address pins are used to determine the device address.

2. Summary

MPLAB Harmony is a flexible, abstracted, fully integrated firmware development environment for PIC32 MCUs. It enables robust framework development of interoperable RTOS-friendly libraries with quick and extensive Microchip support for third party software integration. MPLAB Harmony includes a set of peripheral libraries,drivers and system services that are readily accessible for application development. The code development format allows for maximum re-use and reduces time to market.

3. Features

    1. 16-Bit Remote Bidirectional I/O Port:

         - I/O pins default to input

    2. High-Speed I2C Interface (MCP23017):

         - 100 kHz

         - 400 kHz

         - 1.7 MHz

    3. High-Speed SPI Interface (MCP23S17):

         - 10 MHz (maximum)

    4. Three Hardware Address Pins to Allow Up to Eight Devices On the Bus

    5. Configurable Interrupt Output Pins:

         - Configurable as active-high, active-low or open-drain

    6. INTA and INTB Can Be Configured to Operate Independently or Together

    7. Configurable Interrupt Source:

         - Interrupt-on-change from configured register defaults or pin changes

    8. Polarity Inversion Register to Configure the Polarity of the Input Port Data

    9. External Reset Input

  10. Low Standby Current: 1 µA (max.)

  11. Operating Voltage:

         - 1.8V to 5.5V @ -40°C to +85°C

         - 2.7V to 5.5V @ -40°C to +85°C

         - 4.5V to 5.5V @ -40°C to +125°C

4. Pin configuration

5. PINOUT DESCRIPTION