MFR25SFRE52-750K

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Through Hole Resistors are one of the oldest electrical components and part of the basic electronic building blocks. In the electronics industry, resistors are used to control the flow of electrical current, and their use can be found in almost all circuits and devices. The MFR25SFRE52-750K is a type of through hole resistor which is a resistive component with two terminals that is installed by mounting the component into a drilled hole on a printed circuit board (PCB). Its application field and working principle will be discussed in this article.

A key application of Through Hole Resistors is in voltage or current regulation circuits. It is often necessary to limit the amount of power supplied to a component or circuit, to reduce any potential or actual damage to them that could be caused by too much power. In these cases, the amount of electrical power supplied are regulated by using Through Hole Resistors, or the addition and removal of several resistors in parallel or series in order to obtain different resistance values. Resistor capacity is measured in Ohms, and the higher the Ohms rating then the greater the resistance will be. Ideally when using Through Hole Resistors for current regulation, they should be selected to closely match the desired output level of the circuit.

In addition to current regulation circuits, Through Hole Resistors can also be used to create waveforms such as sine, square or triangle waveforms. They can also be used to create smoothing circuits in order to reduce power supply or signal line noise. Through Hole Resistors can also be used as a grounding element for a circuit. This is to prevent any undesirable electrical charges from entering the circuit.

Due to its construction, The MFR25SFRE52-750K is a robust and durable component, featuring an anodized aluminum case which is sealed and restricted to air and water, protecting against dust, dirt and other contaminants. The MFR25SFRE52-750K is rated for a maximum power of 750K ohms, and is designed to be soldered directly into the PCB hole and bonded to the board with solder. It is also capable of withstanding temperatures of up to 200 degrees Celsius.

The working principle of The MFR25SFRE52-750K is based on the concept of resistance. This is a measure of the opposition to the flow of current in a circuit. A larger amount of resistance will require more power to drive the same amount of current through the resistor, and will thus result in more heat being generated in the resistor. This heat generated by the resistor is then dissipated into the surrounding environment.

Through Hole Resistors can be used in a wide range of applications, from low-power consumer electronics to high power industrial circuits. The MFR25SFRE52-750K is an example of a Through Hole Resistor that is suitable for many different applications, such as current limiting, waveform generation and cooling solutions. It is an ideal component for electrical engineers and technicians looking for an efficient and reliable solution to their power or noise management needs.

The specific data is subject to PDF, and the above content is for reference