MPR12-3YD220V

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Panel Indicators, Pilot Lights are devices used to signal various operating conditions, often times in industrial environments. One such device is the MPR12-3YD220V, which is an LED based pilot light and is used to indicate that electricity is applied, as well as other switch and control indications.

The MPR12-3YD220V typically has a 12mm wide panel cutout and with a depth of 42mm, it fits in shallow panels. It also has a drive voltage of 3 VDC/220V AC voltage and a current drain of 20mA for the output mode and 0.1mA in rest mode. This LED device is designed to accept both AC or DC current, meaning a single device can be used in a range of applications.

The MPR12-3YD220V is most commonly used in industrial and commercial settings to indicate signals for a current being applied, or to signal that a command has been sent or accepted. In a panel setting, this means that it will alert an operator when something is active, allowing them to make better informed decisions.

The MPR12-3YD220V LED Indicator works on the principle of allowing current to go through the LED bulb, causing it to light up. The device is designed to accept different electrical currents, meaning different amp requirements will result in different output voltages. When the current travels through the resistor and applies voltage to the LED, it will then light up and indicate the presence of current or a signal.

The MPR12-3YD220V LED is commonly used as a warning beacon, as it can easily be seen in both indoor and outdoor areas. It can be used to signal problems, emergency drill, or hazardous conditions with the use of appropriate codes and alerts. This device is also often found in industrial and commercial settings, where it can provide visual indicators for various operational signals.

In terms of installation, the MPR12-3YD220V LED pilot light is simple to install. The panel cutout requires a diameter of 12mm and a depth of 42mm, after which it is simply a matter of connecting the unit to the device in question via the appropriate circuitry. After it is installed, the device should be tested to ensure proper operation before being left alone.

The MPR12-3YD220V LED Indicator is a reliable and efficient way to provide visual indications of current applications, control switch signals, and other operations. This device can be used in a wide range of different industrial and commercial applications, allowing operators to easily identify potential issues before they become a problem.

The specific data is subject to PDF, and the above content is for reference