ROX3SJ1R2

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Through hole resistors are a critical component for maintaining a stable and reliable circuit board design. The ROX3SJ1R2 resistor is a through-hole device and is designed for use in applications that require a stable, accurate, and consistent resistance value. This type of resistor is also highly reliable and has a 50,000-hour operating life, thus making them ideal for high-frequency and high-power applications.

The ROX3SJ1R2 resistor is made up of a combination of a high temperature and high current copper winding, which is covered with a special insulating material. This design ensures that the resistor can operate in high temperature and high power environments without the risk of heat or electrical damage. The resistor also features a soldered connection, which makes it highly reliable and very easy to install.

The ROX3SJ1R2 through-hole resistor is typically used to control the current, voltage, and the temperature of an electrical circuit. It is also used as a voltage regulator in power supplies, CE or consumer electronics, and medical equipment. In addition, this type of resistor is frequently used to regulate the input/output signals of an amplifier or signal processor, as well as in some RF circuits.

The working principle of the ROX3SJ1R2 through-hole resistor is based on the principle of Ohm\'s Law. Ohm\'s Law states that the resistance of a material is measured in ohms and is represented by the equation R=V/I, where R is the resistance of the material, V is the voltage across the material, and I is the current through it.

The resistance of a resistor is determined by its resistance value, which is specified using a three-digit “EIA code”, a three-digit “Series Code” and a three-digit “Price Code”. The “EIA code” specifies the size of the resistor, the “series code” specifies the resistance value, while the “price code” specifies the cost of the resistor.

When a voltage is applied across the resistor, the current will flow through it and the voltage across the resistor will be proportional to the current. This proportionality is described by Ohm\'s Law. As the current increases, the voltage across the resistor will also increase according to the equation. If the voltage is increased too high, the resistor will begin to heat up and may fail and burn out.

In summary, the ROX3SJ1R2 through-hole resistor is an ideal choice for applications that require consistent, reliable, and accurate performance. It is designed to operate in high temperature and high power environments without the risk of heat or electrical damage, making it ideal for a variety of applications. It works on the principle of Ohm\'s Law, where the voltage across the resistor is proportional to the current through it. This makes it an ideal choice for regulating input/output signals of amplifiers and signal processors, as well as in power supplies, CE or consumer electronics, and medical equipment.

The specific data is subject to PDF, and the above content is for reference