RPS164PJ224CS

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Resistor networks, arrays, and bridging circuits are components that are often used to either reduce the amount of current in a circuit or to split the current to different paths in the circuit. The RPS164PJ224CS is a resistor network that is designed to be used in different ways. This article will explain the application field and working principle of the RPS164PJ224CS.

The RPS164PJ224CS is a four-resistor network designed for applications where low power dissipation, high accuracy, and low cost are necessary. The RPS164PJ224CS has five pins: a plus, minus, and three isolated pins. Two of the isolated pins are connected to two resistors and the third is connected to a third resistor. The fourth resistor is in parallel with the three resistors. The resistors are all equal in size and value. This configuration of resistors allows the network to be used as a voltage divider or attenuator. Furthermore, it has a load capacity of 100 mA, and can be used in applications up to 150 V.

The RPS164PJ224CS can be used for many different applications, such as signal conditioning, radio frequency (RF) and microwave amplifiers, line matching circuits, and transmission line matching circuits. In addition, it can be used to divide an AC or DC voltage, which may be used for power distribution or controls in industrial circuits. The resistors can also be used as linear resistors for power supplies.

When using the RPS164PJ224CS as a voltage divider, current flows through the two resistors in series, and then the third resistor in parallel. The voltage is proportional to the value of each resistor. The voltage at the third isolated pin will be proportional to the parallel resistor. This allows the circuit to have a wide range of possibilities. For example, if the two resistors in series have values of 100 ohms each, and the parallel resistor has a value of 500 ohms, then the voltage at the third isolated pin will be four times the voltage at the other two pins.

In addition, when using the RPS164PJ224CS as a voltage attenuator, the resistors can act as a voltage-controlled current sink or leak. The current flow will follow Ohm’s Law, where the voltage will be proportional to the resistance value. By adjusting the value of the resistors, the current flow can be adjusted. The voltage at the third isolated pin will remain constant, and the voltage at the other two pins will correspondingly adjust.

In conclusion, the RPS164PJ224CS is a versatile four-resistor network that can be used for many different applications, including voltage division and attenuation. This can be adjusted by changing the values of the resistors. It is designed for both AC and DC applications and has a load capacity of up to 100 mA. Finally, it is a cost-effective and reliable solution that can be used in industrial, RF, and microwave circuits.

The specific data is subject to PDF, and the above content is for reference