SIT1602BC-23-30E-33.000000E

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

An oscillator is a circuit that creates and maintains a periodic signal. It is used in many applications for generating and shifting the frequency of an electronic signal. The SIT1602BC-23-30E-33.000000E oscillator is a type of voltage controlled oscillator (VCO) designed for oscillating between 30MHz and 40MHz, at a supply voltage of less than 3.3V. 

This oscillator is a two-stage CMOS VCO and can generate stable RF signals over a wide frequency range. The PLL architecture of the oscillator enables it to provide a high frequency accuracy and low jitter output to meet high frequency synchronization requirements. The oscillator is designed to provide high isolation and has good noise performance. It also has a low power consumption and can generate high-frequency stable waveforms even at low input frequencies.

When the oscillator is powered up, the chip starts to oscillate at a frequency determined by the voltage of the supply voltage. This can be adjusted by adjusting the voltage of the supply voltage. The output of the oscillator will then be a sinusoidal waveform with a frequency that is set by the voltage of the supply voltage. This voltage can be varied to set the frequency of the oscillation. As the voltage increases, the frequency of the waveform will increase and as the voltage decreases, the frequency of the waveform will decrease.

The oscillator has two separate circuits for the amplification and the oscillator. The first circuit amplifies the input signal before it enters the oscillator. This is done in order to make sure that the generated waveform is stable and accurate. After the signal has been amplified, it is then sent to the oscillator circuit. The oscillator circuit then uses the amplified signal to generate an oscillation at a predetermined frequency and then sends the oscillation out via the output port. 

The SIT1602BC-23-30E-33.000000E oscillator is used in many applications such as telecommunications, radio communication, timing devices, and other similar applications. It can be used to generate signals that are used in communication systems or to provide timing signals that are used in microcontrollers and embedded systems.

The SIT1602BC-23-30E-33.000000E oscillator is a useful tool in many applications and can provide stable and accurate signals for a wide range of applications. It is a cost-effective and powerful device that can provide reliable signals with excellent performance. 

The specific data is subject to PDF, and the above content is for reference