SL1021B230C

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

 Gas Discharge Tube Arresters (GDT) are designed to protect electrical equipment from transient overvoltage caused by lightning and other external factors. They are usually used in outdoor environments to control large currents or to protect sensitive equipment sensitive to overvoltage or to help reduce the risk of fire or damage to property. The SL1021B230C is a type of Gas Discharge Tube Arrester (GDT).

The SL1021B230C encompasses two main components, a voltage-dependent low impedance element and a gas-filled tube. The main function of the voltage-dependent low impedance element is to monitor and stabilize the voltage to an acceptable level. The other component, the gas-filled tube, is the actual arrester, which protects against overvoltages by providing a short-circuit (<1 ohm) after voltage surpasses a certain value. This device relies on a principle that the insulation resistance of a gas-filled tube increases significantly when the voltage across the electrodes of the tube is below a certain threshold, and decreases drastically when the voltage rises above the threshold.

The SL1021B230C can be set up to operate in either unipolar or bipolar working modes. In unipolar mode, power is supplied from one electrode, and the other is grounded to allow for a controlled current leak. In bipolar mode, power is supplied to both electrodes of the arrester, enabling a low impedance path to be created, allowing a higher current to flow through the arrester.

The SL1021B230C is most commonly used in telecommunications, power plants, and in the aerospace industry. In telecommunications, the SL1021B230C can be used to protect the central office equipment and local access lines from damage caused by power outages and surges on the line. In power plants, the SL1021B230C can be used to protect the power generating system from lightning strikes as well as from voltage spikes caused by large load reductions on nearby circuits. In the aerospace industry, the SL1021B230C can be used to protect sensitive avionic equipment from static charges that can be experienced in high altitude environments.

When it comes to installation, the SL1021B230C must be connected to an appropriate overvoltage protection system in order to work properly. The connections for the system should be made from the device to a switchgear connected to the ground. The SL1021B230C should then be connected to the switchgear and the overvoltage protection system. The SL1021B230C should also be connected to the circuit breaker, so that the circuit breaker can disconnect the overvoltage protection system when it detects an overvoltage event.

Finally, it is important to use the correct installation procedures when installing the SL1021B230C. The SL1021B230C should always be mounted in a position where it can receive an adequate amount of cooling air and be connected securely to the ground. The arrester should also be tested before and after installation to ensure that it is working correctly.

In conclusion, the SL1021B230C is a type of Gas Discharge Tube Arrester (GDT) that is designed to protect electrical equipment from transient overvoltage caused by lightning and other external factors. It can be set up to operate in either unipolar or bipolar working modes, and its main components are a voltage-dependent low impedance element and a gas-filled tube. The SL1021B230C is commonly used in telecommunications, power plants, and the aerospace industry. When it comes to installation, the SL1021B230C must be connected to an appropriate overvoltage protection system and tested before and after installation to ensure that it is working correctly.

The specific data is subject to PDF, and the above content is for reference