VE0603M300R006

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

A varistor, such as the VE0603M300R006, is a non-linear electrical component that provides electrical protection and filtering. Varistors also can be referred to as Voltage Dependent Resistor (VDR), Metal Oxide Varistor (MOV), or Voltage Suppressor (VSR). They are mainly used to reduce or limit the surge voltage and current that occurs in an AC circuit due to a capacitor or inductor being connected to that circuit.

Purpose

Varistors are used to provide power protection for electrical systems and components. They limit the amount of voltage that is allowed in a circuit, and also act as a filter to reduce radio frequency interference (RFI). Varistors are commonly used in power supplies, DC to AC inverters, electronic circuits, and other electrical and electronic devices.

Working Principle

The VE0603M300R006 varistor works by allowing a small current to pass through when a certain voltage level is exceeded. This is known as its "breakdown" or clamping voltage. The current through a VDR typically increases as the voltage increases, and the voltage decreases as the current increases.

The VDR has two terminals: a positive and negative. The positive terminal is the point of connection for the power source, and the negative terminal is connected to the circuit\'s ground. The greater the voltage between the two terminals, the higher the current will flow. The VDR\'s break down voltage is determined by the composition of its ceramic material. Typical breakdown voltage ratings for the VDR range from 5-840 volts.

Limitations

Varistors have some limitations. They are limited to the amount of current that they can handle. Exceeding the rated current can cause permanent damage or even failure of the varistor. Moreover, VDRs have limited reverse stand-off voltage, which means that they will not protect against reversed voltages. In addition, while they are able to protect against some levels of overvoltage, they can not protect the equipment from an extreme overvoltage event.

Conclusion

The VE0603M300R006 varistor is a non-linear electrical component that provides electrical protection and filtering. It is mainly used for power protection and filtering for electrical and electronic equipment. The VDR works by allowing a small current to flow when a certain voltage level is exceeded. Varistors have some limitations and should not be used for extreme overvoltage protection.

The specific data is subject to PDF, and the above content is for reference