Allicdata Part #: | XWM8734EDS/RV-ND |
Manufacturer Part#: |
XWM8734EDS/RV |
Price: | $ 2.30 |
Product Category: | Integrated Circuits (ICs) |
Manufacturer: | Cirrus Logic Inc. |
Short Description: | IC CODEC AUDIO STEREO 20SSOP |
More Detail: | Stereo Audio Interface 24 b Serial 20-SSOP |
DataSheet: | XWM8734EDS/RV Datasheet/PDF |
Quantity: | 1000 |
2000 +: | $ 2.08637 |
Series: | -- |
Packaging: | Tape & Reel (TR) |
Part Status: | Active |
Type: | Stereo Audio |
Data Interface: | Serial |
Resolution (Bits): | 24 b |
Number of ADCs / DACs: | 2 / 2 |
Sigma Delta: | Yes |
S/N Ratio, ADCs / DACs (db) Typ: | 90 / 100 |
Dynamic Range, ADCs / DACs (db) Typ: | 90 / 95 |
Voltage - Supply, Analog: | 2.7 V ~ 3.6 V |
Voltage - Supply, Digital: | 2.7 V ~ 3.6 V |
Operating Temperature: | -40°C ~ 85°C |
Mounting Type: | Surface Mount |
Package / Case: | 20-SSOP (0.209", 5.30mm Width) |
Supplier Device Package: | 20-SSOP |
Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us: sales@allicdata.com
The XWM8734EDS/RV is a monolithic isolated, isolated, isolated differential amplifier and is one of the most commonly used interface-codecs. Its primary application field is amplifier isolation, but it can also provide good isolation protection in a variety of other applications.
The XWM8734EDS\/RV is designed for high-speed signals, lower power dissipation, wide bandwidth, low distortion, and low noise. It is typically used as a differential amplifier for zero crossing isolation and signal conditioning applications, such as, analog-to-digital converter (ADC) receivers, audio amplifier interfaces, microphone preamplifiers, sensor signal conditioning and data transmission.
The XWM8734EDS\/RV consists of two differential amplifiers that can be used for gain or compensation. The differential amplifiers have a wide input dynamic range and can accept input voltage up to 4 V peak-to-peak. The wide low frequency cutoff is typically set at 300 KHz, with an upper frequency limit of 25 MHz. This device also features a total harmonic distortion (THD) of less than 1%.
The working principle of the XWM8734EDS\/RV is relatively simple. The first differential amplifier is used to amplify the input signal before it is sent to the output; the second differential amplifier is used to compensate for the input signal, which allows the circuit to reject any noise or interference that may be present in the signal. The output signal is then amplified before being sent out of the device.
Analog signals are strongly affected by noise, which can make them noisy or distorted. The XWM8734EDS\/RV is designed to reduce this noise and distortion, allowing for a clean signal to be output. The noise signal can be reduced by using a differential amplifier, in which the input signal is split into its differential components (positive and negative) before being further amplified to reduce the rate of interference. This technique is commonly referred to as differential pair gain.
The XWM8734EDS\/RV is an ideal choice for amplifier isolation, signal conditioning, and data transmission applications. Its features and design make it suitable for a variety of applications. Its two differential amplifiers allow it to reduce noise and distortion, while its wide dynamic range, low power dissipation, and optimized high frequency performance provide a high fidelity signal.
The specific data is subject to PDF, and the above content is for reference
Part Number | Manufacturer | Price | Quantity | Description |
---|
XWM8734EDS/RV | Cirrus Logic... | 2.3 $ | 1000 | IC CODEC AUDIO STEREO 20S... |
XWM8734EDS/V | Cirrus Logic... | 3.6 $ | 1000 | IC CODEC AUDIO STEREO 20S... |
IC CODEC 6CH 192KHZ 64LQFPAudio Interfac...
IC AUDIO CODEC HD 4CH 48-TQFPAudio, HD I...
IC VOICEBAND CODEC 3V 1CH 20SOPPCM Inter...
IC STEREO AUDIO CODEC 28VQFNStereo Audio...
IC VOICE/MODEM CODEC 24-SSOPVoice-Band I...
IC CODEC STER/SUDIO SPDIF 44QFPStereo Au...