0430300002-04-R2

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Jumper Wires

Jumper wires are electrical cables that have already been crimped and soldered. They are used to connect two electrical components or circuits together. They are typically made of heavy duty copper or steel cable. The crimped ends are usually insulated with a coating of vinyl, insulation, or plastic to protect them from shorting out in wet environments. Additionally, the ends of the wires often have pins or terminals which can be used to easily connect to the circuit board.

In order for the jumper wires to work properly, the proper crimping technique must be used. If the crimp is too tight, the wire can become loose if the power is interrupted, which can cause a short circuit or other electrical failures. On the other hand, if the crimp is too loose, it can cause poor electrical connections, leading to poor performance.

Jumper wires are often used in hobbyist electronics, such as Arduino boards, Raspberry Pis, and other microcontroller boards. They are also commonly used in commercial and industrial applications, where the connections must be secure yet easily accessible. In addition, they can be used as a temporary solution when a permanent wiring solution is not yet available.

Pre-Crimped Leads

Pre-crimped leads are electrical components which have already been crimped with a terminal or connector. They are used to make quick and reliable connections between two circuits. Pre-crimped leads are usually made with high quality copper or steel cables, and they are covered in a protective coating of insulation to prevent shorting.

The use of pre-crimped leads has a variety of advantages. The wires are easier to connect than crimping wires by hand, as they are already crimped and ready to use. Additionally, they are more durable, as the crimping is more secure and the connection is less likely to be affected by environmental factors. Finally, they are easier to test than hand-crimped leads, as the crimp can be easily checked before the connection is made.

Pre-crimped leads are frequently found in electrical equipment, such as circuit boards, motors, and controllers. They are also commonly used in automotive applications, as they are able to withstand the high temperatures and pressures found in many vehicles. In addition, they are often used in home electronics, as the operation of many devices is dependent on reliable connections.

0430300002-04-R2 Application Field and Working Principle

The 0430300002-04-R2 is an insulated copper jumper wire designed for use in a wide range of applications. It is a single-core wire, with a two-pin connection to the copper conductor. It has a general operating temperature range of -40°C to 105°C.

The working principle of the 0430300002-04-R2 is relatively simple. The two pins at the end of the wire are connected to a copper conductor, which is then connected to a power source. This creates an electrical connection between the two pins, allowing current to pass through the wire. The insulation around the wire prevents short circuits and protects the wire from environmental factors.

The 0430300002-04-R2 is commonly used in a variety of applications, including industrial automation, automotive wiring, and home electronics. It is also sometimes used as a replacement for traditional wire nuts in electrical systems. Additionally, the 0430300002-04-R2 can be used to make “jumper” connections between two components, allowing current to flow through the wire without the need for a separate connector.

The specific data is subject to PDF, and the above content is for reference