74ACT11245PWE4

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The 74ACT11245PWE4 is an octal buffer driver designed for operation with 3.3V or 5.0V supply voltages. With its open drain outputs, the device allows up to 64mA sink capabilities and is used to translate signal levels between two different logic families which operate at different voltage levels. It is also used to buffer signals to drive long cable runs and reduce signal reflections, or to drive signals into terminated lines for better signal integrity.

The 74ACT11245PWE4 is used in a variety of applications. It is often used to pump as many as 20mA current from a single signal pin to an output pin. This is useful in applications where a signal must be transmitted over a long run, such as in high speed communication equipment. The buffer also helps to reduce signal reflections on the output, which can create signal distortion and timing problems. It is also used in application interfaces which require logic level conversions between different logic families, such as between a 5V logic system and a 3.3V logic system. Circuit protection and isolation functions are also served by the device.

The inputs of the 74ACT11245PWE4 are TTL compatible, and the outputs are open drain, meaning that they can sink current, but not source it; they must be pulled up to the desired logic level. The devices are designed to operate with either 3.3V or 5.0V supply voltages, and they can accept input voltages as high as 7.0V without affecting the output too much.

The working principle of the 74ACT11245PWE4 is relatively simple. The signals on the input pins are buffered and translated by the transistors in the device to the desired logic levels on the output pins. The output levels are determined by the voltage applied to the supply pin of the device. If the supply voltage is 3.3V, then the output voltage will be around 3.3V. If the supply voltage is 5.0V, then the output voltage will be around 5.0V. The input signals can be of different logic families, so long as their logic levels match the supply voltage applied to the device. This allows for compatibility with different logic families at different voltage levels.

The 74ACT11245PWE4 has a wide range of applications, where signal translation, signal buffering, and voltage translation are required. It also helps to reduce signal reflection on long transmission lines and increase signal integrity. With its open drain topology and ability to interface between different logic families, it is the perfect partner for any circuit which requires fast logic level conversions, buffering, or signal protection.

The specific data is subject to PDF, and the above content is for reference