93C76CT-E/MS

Series:	--
Packaging:	Tape & Reel (TR)
Part Status:	Active
Memory Type:	Non-Volatile
Memory Format:	EEPROM
Technology:	EEPROM
Memory Size:	8Kb (1K x 8, 512 x 16)
Clock Frequency:	3MHz
Write Cycle Time - Word, Page:	2ms
Memory Interface:	SPI
Voltage - Supply:	4.5 V ~ 5.5 V
Operating Temperature:	-40°C ~ 125°C (TA)
Mounting Type:	Surface Mount
Package / Case:	8-TSSOP, 8-MSOP (0.118", 3.00mm Width)
Supplier Device Package:	8-MSOP
Base Part Number:	93C76C

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Introduction
The 93C76CT-E/MS is a 256 x 8 Serial EEPROM, making it useful for typical embedded applications with low-capacity memory requirements. 93C76CT-E/MS are fully compatible with the JEDEC standard. It is used in micro-controller memory storage, data protection and PCI/ISA device programming. It is user-programmable and provides excellent reliability, low power consumption and a data retention of 10 years.

Memory Classification
93C76CT-E/MS is classified as a non-volatile memory. Non-volatile memory devices are different from RAMs, as they are able to maintain their data when the power is switched off. This type of memory can be erased and programmed with new data, allowing it to be used in a variety of applications, such as microcontroller memory storage and data protection.

Application Fields
93C76CT-E/MS can be used in various application fields including embedded systems, computer systems, consumer electronics, and automotive electronics. For instance, it is used to store configuration and parameters in embedded applications, to store the BIOS in computer systems, to store passwords and encryption keys in consumer electronics, and to store engine control parameters in automotive electronics. The low power consumption and excellent reliability make the 93C76CT-E/MS suitable for numerous embedded applications.

Working Principle
93C76CT-E/MS use three-wire bus protocol for communication. It consists of 3 pins: Clock (SCLK), Data (SI), and Chip Select (CS). The data is read or written serially, with a single bit sent at a time. To write data, first the CS pin must be driven low to enable the device, followed by the sending of the Start conditions. The device address is then sent with the data direction bit, followed by the data byte. After the data is written, the Stop condition admits that the data has been successfully written. Similarly, to read data, the CS pin must first be driven low, followed by the sending of the Start conditions and the device address byte, followed by the data byte. Finally, the Stop condition is sent and the data is read.

Conclusion
The 93C76CT-E/MS is a non-volatile memory device with a wide range of applications. It offers excellent reliability, low power consumption and a data retention of 10 years. The 93C76CT-E/MS use a three-wire bus protocol to communicate with the controlling micro-controller, making it easy to interface. The 93C76CT-E/MS is a suitable memory solution for various embedded applications.

The specific data is subject to PDF, and the above content is for reference

Part Number	Manufacturer	Price	Quantity	Description