93LC56A-E/ST

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

93LC56A-E/ST is a kind of memory device manufactured by STMicroelectronics. It is an EEPROM (Electrically Erasable Programmable Read-Only Memory) device, which is an ideal solution for applications where data must be retained when the power is removed. 93LC56A-E/ST Memory devices are well suitable for battery-backed systems and often used in embedded applications such as industrial automation and consumer electronics.

93LC56A-E/ST memory devices are 8-pin devices, featuring clock control, chip enable and write enable inputs. The device offers two different power supply systems. If required, 2.7V-5.5V and 1.8V-5.5V can be applied at the same time. It features a serial I2C bus interface with a maximum clock frequency of 400 kHz and an Access Time of 250 ns/byte.

In terms of memory capacity, 93LC56A-E/ST features 128/256 bytes of internal EEPROM memory. The network can be programmed 1 byte at a time and data is readable 1 byte at a time. Moreover, 93LC56A-E/ST memory devices include additional features such as write protection (WP) and Hardware Data Protection (HDP). The device offers two data blocking modes for preventing accidental data corruption due to inadvertent write cycles. Furthermore, 93LC56A-E/ST memory is capable of offering 100,000 write/erase cycles.

In term of applications, 93LC56A-E/ST memory devices are mainly found in the automotive industry, such as car keys, engine control systems and on-board diagnosis modules. It is also found in many consumer electronic products such as TV remote controls, digital cameras and gaming devices. 93LC56A-E/ST memory devices are also used in industrial automation, medical equipment, security access, metering and smart cards.

In terms of operating principle, 93LC56A-E/ST is made up of a number of single transistors, each memory cell storing one bit of data. The write process of the device starts with a control signal, followed by data and address. This process is then followed by the chip enable and write enable signal. Upon receiving these signals, the memory cell is ready to write data. In EEPROM technology, electrons are used to write data and the data is stored until erased. The process of erasing data is similar to the process of writing, but requires a higher amount of voltage and longer duration.

As mentioned above, 93LC56A-E/ST memory devices are well suited for a wide range of embedded applications. With its robust operating temperature range, low-power consumption, fast access time and low cost, 93LC56A-E/ST devices are thoughtfully designed to help the designer gain a competitive advantage in the market.

The specific data is subject to PDF, and the above content is for reference