AT17N256-10SC

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

AT17N256-10SC is a 256-Kbit PROM configured for use with FPGA (Field Programmable Gate Arrays). It can be used in a variety of applications from configuring devices to prototyping or rapid developing. It features a JEDEC approved 25-MHz SOIC-24 package that helps in pin-compatible replacement of memories used in these applications.

The AT17N256-10SC device is based on a two-wire interface, a standard Serial Peripheral Interface (SPI) protocol. The device offers storage of up to 32K bytes of read-only memory and can be configured using a host processor. The device can also be programmed using an in-system programmable FPGA.

The device can be clocked up to 25 MHz and offers an erase-program-verify feature. It is verified after every erase/program cycle and offers both address/data protection and scratch-proof protection of bit patterns.

The AT17N256-10SC device is also operationally compatible with other SPI devices and can be used to control the start-up of multiple devices in a single application. It offers a variety of NOVICE modes of operation, allowing programming and testing at the same time while keeping timing hazards and flow simulations at their minimum.

The AT17N256-10SC is suitable for design prototyping, rapid product development, network control nodes, embedded control, medical and consumer product software, and application- specific systems.

The working principle of AT17N256-10SC is straightforward and simple. After being connected to a host processor or FPGA, the device transmits its information to the controller via a Serial Peripheral Interface (SPI) protocol. The host processor sends instructions to the PROM, which then stores the information. The information is stored in a flash-based memory which offers fast read/write speeds and consumes low power.

Once the data is stored in the PROM, it can be accessed again. The AT17N256-10SC device can be clocked up to 25 MHz, providing an optimum solution for application-specific systems that require high speeds and low power consumption. The device can also overwrite the stored information if needed.

The AT17N256-10SC chip acts as a bridge between the host processor and the memory. By connecting the two together, the user can easily configure the device and access the stored information. This makes it an ideal solution for applications that require fast and reliable storage of information.

In conclusion, the AT17N256-10SC is a perfect device for memory-configuration of FPGAs that require fast, reliable and low-power solutions. It can be used in various applications and offers a Serial Peripheral Interface (SPI) protocol for easy access of information. It also offers an erase-program-verify feature for reliable memory storage and a variety of NOVICE modes for programming and testing the device. With its fast speeds and simple working principle, the AT17N256-10SC is an essential component for configuring FPGAs.

The specific data is subject to PDF, and the above content is for reference