AT25256-10PI-2.7

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The AT25256-10PI-2.7 is a type of non-volatile [memory](https://en.wikipedia.org/wiki/Non-volatile_memory). This type of memory is designed with the intention of permanently storing electrical memory by writing the data to the memory cell even when power is removed from the system. It is a crucial component for today’s electronics, as it allows for software programs, settings and other important data to be written and stored for future use.

The AT25256-10PI-2.7 specifically is a 256K-bit Serial EEPROM that has been designed for use in ranges of automotive and industrial applications. This particular EEPROM was designed by Microchip and can operate over a wide temperature range of -40˚C to 125˚C. The AT25256-10PI-2.7 features an 8-pin package and can be powered by a single positive supply, either 3.0V or 2.7V depending on the application.

The AT25256-10PI-2.7 is an efficient, non-volatile memory that is ideal for applications such as data logging and control systems that require reliable memory to store important information long-term. These memory devices are capable of storing data without needing constant power, allowing the device to continue to operate in a low power or standby mode.

The most common application for this type of memory is in automotive electronic systems, where it is used to store data such as engine control and power-train control units. It is also used in communications systems such as satellite transmitters and receivers, as well as in industrial systems for data storage and control. The AT25256-10PI-2.7 has also become a popular choice for embedded systems, where it is often used to store firmware, configuration settings, or data required by the system.

The AT25256-10PI-2.7 is a serial EEPROM that utilizes a 3-wire serial interface for data transfer. The interface consists of a serial clock (SCL), serial data output (SDA) and chip select (CS#) line. The chip select line is used to enable and disable the device, and the other two lines are used for the data transfer. The serial interface allows for a maximum data transfer rate of 400kHz, providing a fast, reliable data transfer rate.

The AT25256-10PI-2.7 is a type of EEPROM (electrically erasable programmable read only memory). This type of memory is non-volatile, meaning that the data stored in the memory cells is maintained even when power is removed from the system. This type of memory is commonly used in applications where the data stored is required to remain after power is removed. The most common applications are automotive, communications and industrial applications, where long-term memory is required.

The working principle of the AT25256-10PI-2.7 is fairly simple. The device uses the three-wire serial interface (SCL, SDA and CS#) to connect to the host processor. Data is written to the memory cells using a combination of the chip select and serial clock lines. The data is then stored in the memory cells until is needed to be read by the host processor. The device is capable of retaining data for up to 100 years, providing a reliable and long-term storage solution for embedded systems.

In conclusion, the AT25256-10PI-2.7 is an efficient, non-volatile memory device designed for automotive and industrial applications. It utlilizes a 3-wire serial interface for data transfer and is capable of storing data for up to 100 years, providing a reliable and long-term storage solution for embedded systems. This type of memory is ideal for applications such as data logging and control systems that require reliable memory to store important information long-term.

The specific data is subject to PDF, and the above content is for reference