C8051F330D

Description

C8051F330D devices are fully integrated mixed-signal system-on-chip MCUs. The prominent features are listed below. For the selection of specific product features, see Table 1.1.

    1. High-speed pipeline compatible with 8051 microcontroller core (up to 25 MIPS)

    2. In-system, full-speed, non-intrusive debugging interface (on-chip)

    3. True 10-bit 200ksps 16-channel single-ended/differential ADC with analog multiplexer

    4. 10-bit current output DAC

    5. Precision programmable 25 MHz internal oscillator

    6. Up to 8 kB on-chip flash memory-512 bytes reserved

    7. 768 bytes of on-chip RAM

    8. SMBus/I2C, enhanced UART and enhanced SPI serial interfaces implemented in hardware

    9. Four general-purpose 16-bit timers

  10. Programmable counter/timer array (PCA) with three capture/compare modules and watchdog timer Features

  11. On-chip power-on reset, VDD monitor and temperature sensor

  12. On-chip voltage comparator

  13. 17-port I/O (5 V resistant)

Through on-chip power-on reset, VDD monitor, watchdog timer and clock oscillator, C8051F330D devices are truly independent single-chip system solutions. Flash can It can even be programmed online, provides non-volatile data storage, and can be upgraded on site 8051 firmware. User software can fully control all peripheral devices and can be turned off individually Any or all peripheral devices to save power.

The on-chip Silicon Labs 2-wire (C2) development interface allows non-intrusive (not using on-chip Resources), full speed, online debugging (using the production MCU installed in the final application). This one Debug logic supports checking and modifying memory and registers, setting breakpoints, single Step, run and pause commands. When debugging, all analog and digital peripherals are fully functional Use C2. The two C2 interface pins can be shared with user functions, thus enabling in-system debugging without occupying package pins. In the industrial temperature range (-40 to +85°C), the operating voltage of each device is 2.7 to 3.6V. The port I/O and RST pin can withstand input signals up to 5 V. C8051F330D can be used 20-pin QFN package (also called MLP or MLF package). Lead-free (RoHS compliant) package It can also. 

Product Selection Guide

LMP-20 Pinout Diagram