HCPL-0700#060

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Optoisolators are an electronics device used in many industries to isolate signals between different sections of an isolated system. The HCPL-0700#060 is one such optoisolator device that is used in many applications, and its working principle is based on the transfer of energy from one system component to another in order to achieve the desired isolation.It is an optoisolator transistor with a photovoltaic output. This device utilizes light to transfer electric signals between physical components. It is a four-pin device, where the first two pins are the control input and the output power pins, while the last two pins are the ground and the output inform signals. The control input of this device is connected to the power source, while the output signal pins (last two pins) are connected to another load, usually a microcontroller or any other system component. When the control signal is applied to the device, a light-emitting diode (LED) inside the device emits light. This light is then picked up by a detector that will create a low output signal. As long as the control input to the device is low, the device will remain in its off state and no output will be produced. The output of the device is generated when the control input is raised to a sufficient level. In general, the maximum voltage input of any HCPL-0700#060 optoisolator should not exceed 45VDC and the peak reverse voltage should not exceed 5 V. The maximum power dissipation is 6 mA at 25°C. The operating frequency of this device is in the range of DC to 500 kHz, and the break-down voltage is usually expressed as the BVceo parameter.The main application fields of HCPL-0700#060 optoisolators are in safety systems, power systems, automotive, and instrumentation. In safety systems, they are used to isolate control signals from other sources of voltages, while in power systems, they are used in devices like overcurrent relays and line fault detectors. In automotive, they are used in exterior and interior lighting, while in instrumentation, they are typically used to provide isolation of high-voltage signals.These optoisolators transistor with photovoltaic outputs also offer very good signal integrity and noise performance. They provide protection against transient voltage spikes and have very good insulation resistance. The devices also offer fast response times, low cross-Talk and high impedance, making them suitable for use in high-speed signal transmission applications.In summary, the HCPL-0700#060 is an optoisolator transistor with a photovoltaic output. It is typically used in safety, power, automotive and instrumentation applications for providing signal isolation and protection against transient voltage spikes. It has a maximum voltage input of 45VDC and can be used over a range of DC to 500 kHz. The device has good noise performance, fast response times, low cross-talk and high impedance, making it a reliable and efficient choice for electrical applications.

The specific data is subject to PDF, and the above content is for reference