MAX280CPA

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Interface - Filters - Active

The MAX280CPA is an active filter that is used to filter electrical signals. This type of filter is designed to attenuate unwanted high frequency signals while allowing ones of desirable frequency to pass through. It is commonly used to filter out noise and other unwanted signals in audio applications. The MAX280CPA is a single-pole low pass filter with a cut-off frequency of 12 kHz and a rated current of 0.2A.

An active filter contains active components such as transistors, op-amps and other integrated circuits. Its implementation is much more complex than passive filters. An active filter takes input from the signal source, amplifies it and then divides it into two different frequency bands. The resulting higher frequency signals are then processed and filtered using the active components.

The MAX280CPA is often used as an input section filter in power supplies and switch mode power supply (SMPS) applications. It also finds application in filter networks that are used to reduce noise in audio equipment. The filter attenuates high frequency components of an input signal by a fixed amount. It is designed to be used at the input of an operational amplifier or a RF power amplifier.

The MAX280CPA is constructed with a built-in resistive feedback network that helps to reduce noise and provides a simple and low cost solution. It is an integrated circuit device consisting of an operational amplifier with a suitable input and output filter. The filter contains two stages; an input buffer stage and an output filter stage. The buffer stage works to reduce the effects of noise, offset and other unwanted signals from the input. The output filter stage attenuates higher frequency components from the input signal. The filter has a cut-off frequency of 12kHz and a high pass filter of 60kHz.

In addition to its application in power supply units and in audio equipment, the MAX280CPA active filter can also be used as a pre-amplifier in audio systems. It is used to filter out unwanted frequencies before the signal reaches the amplifier. It can also be used as an active crossover filter, allowing signals of different frequencies to be processed separately.

The MAX280CPA is an example of an active filter that provides reliable performance and is easy to use. It is an ideal choice for filtering out noise and other unwanted high frequency signals in a wide range of applications. It is a cost-effective solution that is able to meet the demands of most applications.

The specific data is subject to PDF, and the above content is for reference