MAX515CSA+

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The MAX515CSA+ is a complete, 8-bit, multiplying digital-to-analog converter (DAC) featuring a buffered voltage output. This device is ideal for low-cost, high-resolution control applications in the process control, test and industrial automation fields. The precision output of the MAX515CSA+ provides 8-bit performance over a wide temperature range with minimal external components.

The DAC can be operated as an independent device or as a secondary device for use with an MCU (Microcontroller Unit). It can be implemented either in a single-chip, 8-bit microcontroller-based system or in a multi-chip, higher performance system. The MAX515CSA+ features an on-board precision reference and a direct interface to an 8-bit data bus. As such, it is suited for use with a variety of microcontrollers, including general-purpose MCUs, as well as with embedded controllers.

The MAX515CSA+ accepts a single A/D reading to generate an analog signal. Such signals can be used to drive power electronics, convert 8-bit digital information into an analog voltage range, monitor an analog signal level, and supply an offset for digital-to-analog signal conversion. The device provides 8-bit digital control over a wide voltage range. At the upper end of the range, the output voltage can be set from 0.25 V to 2.475 V in 0.625 V steps.

The device has a buffered voltage output, a power-on reset input, a high-accuracy voltage reference, and 8-bit digital inputs. The output voltage is determined by the digital input data. The output current is typically 200 uA and short-circuit protected. The output impedance is typically 3 ohms. The voltage reference, which is nominally 2.5 V, is internal to the MAX515CSA+ and is buffered and provided to external circuitry.

The MAX515CSA+ provides an 8-bit parallel interface with 8 inputs. The 8-bit data is supplied to the CLR/LAT, ERR, and CS (Chip select) pins. The data is latched by the CLK pin. The CLK pulse also generates an active low DAC chip select (ACTL) signal. The DAC output is connected to the output pin. A power-on reset input is provided on the DS (Data Set) pin to reset the DAC to its power-up state.

The MAX515CSA+ is ideal for digital control of power devices and for applications requiring low power dissipation, wide range of voltage levels, high accuracy, and fast response. It is also a great choice for digital-to-analog signal conversion and for interfacing with microcontrollers. The device is highly integrated and hence, does not require external components.

The specific data is subject to PDF, and the above content is for reference