MCP4251-503E/P

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Data Acquisition - Digital Potentiometers typically come in the form of integrated circuits. They are used to control the resistance present in a electrical circuit, by providing a signal that can be adjusted to create a desired level of resistance. The MCP4251-503E/P is a digital potentiometer that is commonly used in a variety of industrial, consumer and engineering applications.

The MCP4251-503E/P is a single-channel, 6-bit digital potentiometer IC. It has an electrical operation of 10KΩ, and provides a digital control interface with 8-bit SPI Serial bus. The IC is programmed by the host processor and has 7-bit resistor and 6-bit wiper control registers. Its operating voltage range is from 4.5V to 5.5V, which makes it suitbale for a variety of power supply requirements. In addition, the IC provides a low power supply current of 0.2uA at 2V.

The MCP4251-503E/P can be used to efficiently adjust electronic circuits for different functions. It can be used as a rheostat, adjustable resistor, adjustable voltage divider, or to create a voltage reference. It is often used to adjust the gain, offset and threshold voltage of amplifiers, to match the load resistance of transducers and sensors, or to adjust the gain of wireless receivers. Additionally, it can be used in combination with power management ICs to control the lighting intensity of LCDs and LEDs.

The MCP4251-503E/P is designed to work on the SPI bus. It can receive commands from the host processor and can respond by setting the resistance or “wiper” value on the digital potentiometer. The IC can be programmed to provide a single resistance value, or to vary its resistance in accord with a range of user-defined values. This is achieved by sending different byte commands from the host processor to the digital potentiometer.

The MCP4251-503E/P has a write cycle time of 5ms, and the wiper can be programmed to new settings within 10ms. The SPI port has a clock operated frequency up to 16MHz, and the IC’s logic input can be connected directly to a variety of microcontrollers.

The MCP4251-503E/P has a few specialty features, such as an interrupt pin, an enable pin, a non-volatile memory battery and an input multiplexer. The interrupt pin can be used to inform the processor of a certain event or a certain value of resistance. The enable pin allows the chip to be turned off and on again, which for some applications can help to save power. The non-volatile memory battery allows the wiper value to be kept even when the power is switched off, and the input multiplexer can be programmed to respond to one of two digital inputs.

Overall, the MCP4251-503E/P has many useful features, making it a great choice for data acquisition applications using digital potentiometers. Its low power consumption, a wide operating voltage range, and a flexible output are all big advantages. Its ability to operate on a SPI bus and have a wide range of control commands, makes it suitable for use in many different systems.

The specific data is subject to PDF, and the above content is for reference