MCP4332T-104E/ST

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The MCP4332T-104E/ST Digital Potentiometer is a 6-bit digitally-programmable element that is capable of providing up to 64 wiper positions, each with resolution of 2%. This specific device is a 2-wire serial interface (SPI) device that provides access to internal registers by using the clock and serial data pins. The device itself has a total resistance of 10kΩ, with a resistance-ratio of 32:1 and an absolute tolerance of +-20%.

Originally designed for a variety of general purpose applications, the MCP4332T-104E/ST has seen an increasing use in such fields as data acquisition, digital control systems and impedance matching. In data acquisition, the MCP4332T-104E/ST can be used for the programming and fine-tuning of a wide range of sensor modules, amplifier modules and signal conditioning components. It can be used to adjust the gain of the input signal, the reference voltage, calibration adjustments and temperature compensation.

In digital control systems, the MCP4332T-104E/ST allows users to select an optimum level of control and response characteristics. This allows users to adjust the control algorithms quickly and efficiently, further improving system performance. Finally, in impedance matching applications, the MCP4332T-104E/ST can be used to carefully adjust device parameters such as channel impedance, output power or signal frequency to ensure that the desired result is achieved.

The MCP4332T-104E/ST is able to provide up to 64 unique impedance levels, depending on the value of the external VDD and VSS voltage rails used. This allows the user to define how the device will behave between the two/several voltage levels. Furthermore, the MCP4332T-104E/ST supports both linear and non-linear impedance curves.

On the operational side, the MCP4332T-104E/ST utilizes two separate registers, an address register and data register. The address register is used to select one of three registers, the write register, read register and the potentiometer register. When writing to the MCP4332T-104E/ST, the write register is used to define which register the data will be written to, while the read register is used to read back data from the device. Finally, the potentiometer register is used to directly adjust the wiper position.

When writing data via the SPI bus communcations, the device’s CPOL and CPHA bits must be set to the same configuration during both write and read operations. In other words, the CPOL and CPHA bits must be set the same during all communication to the device. Once the write register is set to select the register to be written or read, all subsequent data sent to or read from the register will be latched onto the serial interface line.

The device also supports two separate shutdown modes, each one having different effects on the performance of the device. The active mode allows the device to draw up to 5mA of current from the VDD source, while the shutdown mode reduces the device current to less than 1µA. This allows the MCP4332T-104E/ST to be used in applications requiring low standby current consumption.

Overall, the MCP4332T-104E/ST digital potentiometer provides users with an easy to use and cost effective solution for adjusting impedances, calibrating Sensors and controlling system parameters. It offers the reliability and accuracy needed in a wide variety of applications, allowing users to quickly and efficiently optimize their systems.

The specific data is subject to PDF, and the above content is for reference