MFR25SFBE52-3K16

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Through Hole Resistors, or THRs, are electronic components that have a number of applications in a variety of electronic applications. The MFR25SFBE52-3K16 Through Hole Resistor is a type of THR. It is a small, cylindrical component with two wires protruding from its body. The two wires are electrically connected within the component. This THR uses a resistor as its component, which absorbs and dissipates electrical energy. The physical size of the component is approximately 0.25 inches in diameter with a length of 3mm.

The MFR25SFBE52-3K16 Through Hole Resistor serves a multitude of purposes in the world of electronics. Its primary application is as a resistor, in which it is used to regulate the amount of electrical current being fed to a specific circuit. Essentially, the THR can be used to decrease or increase the amount of current being fed into a circuit or device.

The THR can also be used in other roles as well. It can be used in a voltage measuring circuit, where it can measure the amount of voltage present in a circuit. It can also be used in an amplifier to increase the voltage of a signal. Additionally, the THR can be used in an oscillator circuit, providing a repeating waveform for the oscillator to work properly.

In order for the THR to function properly, it needs to be hooked up correctly. The THR will have two terminals, one labeled positive and the other labeled negative. The component should be wired such that the positive terminal is connected to the positive side of the circuit and the negative terminal is connected to the negative side of the circuit.

The THR works on the principle of Ohm’s Law, which states that voltage over resistance equals current. When current is applied to the THR, the resistance of the THR will cause a voltage drop. This is because the THR is designed to resist the flow of electricity, thus causing a drop in the amount of voltage. The amount of voltage drops depends on the size of the Resistance of the THR. The larger the Resistor, the more voltage drop will be observed.

THRs are typically made out of metal, such as copper, aluminum, or steel. The metal is usually coated with an insulating material, such as plastic, to protect the metal and reduce resistance. The THR is also connected to a wire or other wiring in the circuit, such as a lead or a terminal strip. The THR is then soldered to the board, creating an electrical connection.

The MFR25SFBE52-3K16 Through Hole Resistor has a vast array of uses in electrical and electronic applications. It can be used as a resistor to regulate current, a voltage measuring device, a signal amplifier, and oscillator. The THR works on the principle of Ohm’s Law and is composed of metal and an insulating material. It is typically connected to wiring on a board by soldering.

The specific data is subject to PDF, and the above content is for reference