MPZ1608S600ATAH0 Filters

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Ferrite beads, such as the MPZ1608S600ATAH0, are small components used for the purpose of reducing interference caused by electrical noise on sensitive electronic circuits. They are specially designed to help minimize that effect, providing additional protection from induced noise and signal deterioration. Ferrite beads are a low cost, high performance, and easy-to-install component which can be found in a variety of applications.

The MPZ1608S600ATAH0 is a ferrite bead manufactured by Murata. It is an ultra-small, surface mount, high-current ferrite chip bead measuring just 1.6x 0.8 mm. It has a maximum DC resistance of 0.60 Ohm, making it ideal for applications where a small, high current ferrite bead is needed. The ferrite bead has a Q value, or quality factor, of 50, indicating that the bead can produce a high-performance power loss reduction over a broad range of frequencies.

The MPZ1608S600ATAH0 ferrite bead has many different applications. It is used in medical equipment, robotics, automotive electronics, data communication systems, and consumer electronics. It can be used to reduce noise from power sources, cables, and other electrical components. It is also used to filter out the effect of electrostatic discharge and other induced noise. Additionally, it can be used in power line applications to protect against interference.

The working principle of a ferrite bead is based on the principle of magnetic field induction. When a current is applied to the ferrite bead, a magnetic field is produced, which then induces a current in the component to which it is connected. This induced current causes the ferrite bead to act as an inductor, rejecting frequencies above and below certain cut-off frequencies to reduce interference and signal degradation. The point at which the ferrite bead will begin to reject frequencies is known as the knee frequency.

In order to maximize the effectiveness of the ferrite bead, there are a few general guidelines which should be followed. The bead should be installed as close as possible to the source of interference, and the frequency of the noise should be below the bead’s knee frequency. The ferrite bead should also be placed on the correct side of the noise source, so that its magnetic field is perpendicular to the line of current flow. Finally, the bead should be designed to handle the anticipated current.

In conclusion, the MPZ1608S600ATAH0 ferrite bead is an ultra-small, high-current ferrite chip bead which can be used to reduce interference and signal degradation in a variety of applications. It works by inducing a current which causes the bead to act as an inductor, rejecting frequencies above and below certain cut-off frequencies. To maximize the effectiveness of the ferrite bead, the bead should be installed as close as possible to the source of interference, and the frequency of the noise should be below the bead’s knee frequency.

The specific data is subject to PDF, and the above content is for reference