MRS16000C3571FCT00

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Through hole resistors, also known as axial resistors, are resistors that have both the terminals aligning in the same direction. These resistors can be either mounted on printed circuit boards (PCB) or can be used for hand wiring, where soldering of terminals is done to secure the part to the board or wire. MRS16000C3571FCT00 is a through-hole resistor, where the component name means the following:

• M – Indicates the component is a metal film resistor.
• R – Shows it is a through-hole resistor.
• S – Identifies the series.
• 16000 – Points to its resistance value in ohms (16K ohms).
• C – Denotes its TCR (Temperature Coefficient of Resistor) value.
• 3571 – signifies its tolerance rate.
• FCT – Refers to its packaging.
• 00 – Computes its power rating.

MRS16000C3571FCT00 is an axial metal film resistor with 64mm long body and machined resistor ID. It is a three-terminal resistor, with a short body, that features a standoff. This type of resistor has high power ratings and low inductance. It is weldable and easily mounts on PCBs.

Due to its high power rating and low inductance, MRS16000C3571FCT00 can be used in different electronic applications with high current loads like switched mode power supplies, motor control, servos, vector drives, amplifiers, etc. This type of resistor also finds application in aircraft, radar systems, and medical equipment. It is capable of enduring high temperature, corrosive atmosphere and vibration.

The working principle of MRS16000C3571FCT00 is the same as that of a conventional resistor. It is based on Ohm\'s law which states that, “the current through a conductor between two points is directly proportional to the potential difference (voltage) across the two points”. The resistor is a passive two-terminal electrical component which is used to resists the flow of electric current, thus opposing the flow of electric charge.

The MRS16000C3571FCT00 resistor can be used in various ways. It can be used in series configurations to divide the current flow between two paths. It can also be used in parallel to add the current flow of two paths. It can also be used as a voltage divider, where the voltage will be divided between two paths based on the series and parallel combination of two resistors. This type of resistor can also be used to control the speed of a motor, by creating the appropriate amount of resistance and decreasing power consumption.

Due to its flexibility and availability in different resistance values, MRS16000C3571FCT00 is widely used in various industries. It is used to limit current flow, dissipate heat, and adjust signal lines. Its low inductance and high power rating make it an ideal choice for applications demanding special power supply performance.

The specific data is subject to PDF, and the above content is for reference