Q4004F41

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Thyristors - TRIACs are widely used in power electronic applications as efficient switching devices. The Q4004F41 is a three-terminal, bidirectional, cruciform, silicon controlled rectifier (SCR) thyristor, which is widely used in industrial, commercial and residential power control applications. It has a blocking voltage rating of 400V and a current rating of 4A. The device can be triggered in two ways: either by gate current or by gate voltage.

The general construction of a TRIAC includes an anode and a cathode with a “gate” section between them. A TRIAC is essentially two SCRs connected in parallel arrangement with a common gate. A potential difference is applied at the gate which when higher than the certain threshold causes current to flow through the device. This causes the device to turn on and allow the current to flow in both directions across the anode and cathode until the current is below a certain value.

The Q4004F41 has two main operating modes: latch off and breakover. When the gate withstanding voltage is below the trigger voltage the TRIAC is in the latch off mode and no current will flow. In breakover mode, the current begins to flow on the positive side when the anode-to-gate potential reaches a certain threshold value. When the gate potential exceeds the gate voltage reverse bias rating, the current on the negative side also starts flowing through the device.

TheQ4004F41 is especially suitable for AC switching applications such as inductive (motor) loads, phase-control dimmers and time relays. The device can be triggered when the voltage applied to the gate is greater than the latching voltage. On the other hand, if no voltage is applied to the gate it should be designed with a zener diode that clamps the gate voltage to the rated latching voltage.

TheQ4004F41 is also suitable for use as a thermal relay in AC circuits as a means to protect motors against overcurrents. The device can be triggered with a short delay after the current reaches a certain threshold value and the device will quickly break the circuit to protect the motor.

Finally, theQ4004F41 can also be used as a load switch in DC circuits. The device can be triggered with a short delay after the voltage reaches a certain threshold value and quickly break the circuit to isolate the load.

In summary, theQ4004F41 is a highly reliable thyristor for controlling AC and DC circuits, especially in applications like inductive loads, dimmers and overcurrent protection. The device is capable of blocking up to 400V and 4A current and can be triggered with a voltage or a current. The device is suitable for a wide range of applications, from simple AC switches and load switches to thermal relays and time relays.

The specific data is subject to PDF, and the above content is for reference