RNC55H1002FRRE6

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

Through hole resistors are components that can be seen in almost any circuit. They are small, relatively simple devices, but they can be used in a variety of ways. The RNC55H1002FRRE6 is a through hole resistor which is used in a variety of applications, most commonly for current limiting, voltage regulation, and protection.

The RNC55H1002FRRE6 is a metal oxide film resistor with a 1% tolerance, a 100kΩ resistance, and a 6W power rating. These resistors are usually constructed with an aluminum oxide layer of patterned film, deposited on a ceramic rod, and then encased in a phenol, epoxy, or polyester type case. Additionally, the resistor is usually color coded to indicate its specific value.

The RNC55H1002FRRE6 has a wide range of applications, and it can be used in both low and high frequency electronic circuits. It is used commonly for current limiting, voltage regulation, and protection in industrial and consumer electronics. It can be used to control the gain and level of an amplifier circuit, or to reduce the voltage output of a power supply. It can also be used to prevent overheating and electrical shorts, as the resistor can limit the current flow through the circuit.

The working principle of the RNC55H1002FRRE6 is simple. By creating a predetermined amount of resistance, it causes a voltage drop along its length due to Ohm\'s law. This means that a current will be established, according to the given resistance and voltage, that will flow through the resistor. This will then either lower or raise the voltage, depending on the application.

As is the case with all through hole resistors, the RNC55H1002FRRE6 must be mounted on a printed circuit board. It has four through holes, one in each corner, which are used to secure the resistor to the board. This provides a good thermal connection, meaning that the resistor does not run too hot and thus ensuring that the current remains consistent.

In summary, the RNC55H1002FRRE6 is a through hole resistor which is used in a variety of applications, most commonly for current limiting, voltage regulation, and protection. Its working principle is simple; by creating a predetermined amount of resistance it causes a voltage drop which can then lower or raise the voltage, depending on the application. The resistor must then be mounted on a printed circuit board in order to ensure the current remains consistent.

The specific data is subject to PDF, and the above content is for reference