SN65LVDM050PWG4

Due to market price fluctuations, if you need to purchase or consult the price. You can contact us or emial to us:   sales@allicdata.com

The SN65LVDM050PWG4 is part of a wide range of interface equipment within the Drivers, Receivers, Transceivers category, designed to allow for control signals to be converted form one form of signal to another. This device, in particular, is designed to convert a LVDS signal into a LVPECL signal, or vice versa. It is capable of conversion at data rates of up to 500 Mbps and can be used in data applications such as TV or audio, where speed and low power are essential.

The LVDS (Low Voltage Differential Signaling) is a non-inverting, differential signaling system capable of data transmissions up to 1 Gbps. It uses two wires with differential voltages, typically between 200 and 800 mV, with a center ground. The two wires are driven by a driver with differential signals, and each wire’s voltage is compared to the ground level by a receiver. The LVDS has superior noise immunity and low power requirements, making it a good choice for high-speed and low-power applications.

The LVPECL (Low Voltage Positive Emitter Coupled Logic) is an inverting logical system with differential signaling, using two voltage levels, typically at 1 Volt. These levels are determined by current sources, one positive and the other negative. Outputs are logic high when positive and logic low when negative, and the reason for different voltages is to avoid input duty-cycle distortion and allow for higher speed data transmission than the LVDS.

The SN65LVDM050PWG4 makes use of a differential input, with both Ends A and B connected to the LVDS driver, and 5 outputs, A, B, I and O. End A is where theDifferential Input Voltage is applied to and Ends B is where ground connection is connected to. End A and B are then amplified on the output ends, A having a positive output current (I) and B having a negative output current (O). The output voltages A and B will be at a fixed ratio, determined by the termination requirement of the load.

It is possible to have both a LVDS and LVPECL driver attached to the SN65LVDM050PWG4, as the device is able to multiplex the two signals. This allows for high speed transmissions without having to use multiple wires. This makes it possible to convert from one form to the other without having to physically connect or disconnect parts. This is especially useful in applications where interference or high speeds can be a problem.

The SN65LVDM050PWG4 has a wide range of applications, from consumer electronics to drones, due to its low power consumption, fast conversion, and excellent noise immunity. As a result, the SN65LVDM050PWG4 is an ideal choice for interfacing with LVDS or LVPECL signals, as it can easily and quickly convert data transmissions across these two forms.

The specific data is subject to PDF, and the above content is for reference